Denon DN-V1700 Operating Instructions Manual

Also see for DN-V1700: Service manual

Contents

Denon DN-V1700 Operating Instructions Manual Manual pdf 18 page image

ENGLISH189 SETTING THE INTERNAL CLOCKThe DN-V1700 is equipped with an internal clock. Set the clock before using the DN-V1700.The clock can be set either by using the controls on the DN-V1700 or by serial port control. For instructions on serial port control, see the“14 Serial Remote Control Terminal” section.2 Setting the date and time using the controls on the DN-V1700Connect the DN-V1700’s video output to an external monitor and turn on the power.1In the stop mode, press the OSD/TIME SET button while pressing the STOPbutton.✽ When the key lock mode is set, cancel the mode using the “KL” serialcommand.STOP OSD/TIME SET2The following appears on the external monitor:“TIME SET MODE”“yyyy/mm/dd-hh:mm:ss” (current date/time)“yyyy/mm/dd-hh:mm:ss” (set date/time)“daylight saving **” (see note below)“yyyy” flashes.TIME SET MODE2001/07/30-16:58:052001/07/30-16:45:28daylight saving xxUse the SKIP button to set the year (A.D.).SKIP3Press the SELECT button to move to the months’ place.SELECT4Repeat steps 3 and 4 to set the date and time.56 Once the setting is completed, press the OSD/TIME SET button. “TIME SET OK”is displayed and the setting is completed.✽ Press the STOP button to cancel the setting.TIME SET OK2 Quick set:Press the PLAY/PAUSE button after step 1 above to reset the seconds to 0.2 Daylight savings time:The DN-V1700’s current daylight savings time setting is indicated at “daylight saving ✽✽” in step 2 above. To change the setting,press the SELECT button to make the “daylight saving” line flash, then press the PLAY/PAUSE button. The clock is moved aheadone hour when the setting is switched from “No” to “Yes”, back one hour when the setting is switched from “Yes” to “No”.2 Automatic setting by SNTP:When the date and time is set by SNTP server when connected to a network, “auto set by SNTP” is displayed at step 2 above. Usethe SELECT button to make “auto set by SNTP” flash, then press the PLAY/PAUSE button. The time can now be set by SNTP.NOTE:When the above setting is made, we recommend repeating the operation in step 1 to check the current time.A super capacitor is used to keep the DN-V1700’s internal clock running even when the power is turned off. The clock keepsrunning for about 7 days after the power is turned off (as long as the power was on for at least one hour beforehand). If the clockstops running, the date and time are reset to “2000/1/1 00:00:00”.