Denon DN-X120 Owner's Manual

Also see for DN-X120: Owner's manual Service manual Owner's manual Quick start guide

Contents

Denon DN-X120 Owner's Manual Manual pdf 7 page image

Connections Playback SpecificationsENGLISHRear PanelQ7 Q8 Q9W0W1W2W3W4W1W2W3W4W5W6Q7 Power operation switch (POWER)Selects power “ON” or “OFF”.NOTE:Whenever the power switch is in the OFF state,the AC adaptor is still connected on AC linevoltage. Please be sure to unplug the cord whenyou don’t use for along time.Q8 Balanced MASTER OUT jacks (BAL.)• These 1/4” TRS jacks provide a balanced linelevel output.• Connect these jacks to the balanced analoginput jacks on an amplifier or console.• Pin layout: Tip=Hot Ring=Cold Sleeve=GNQ9 MIC BALANCED INPUT jack• Accepts an balanced microphone with 1/4” TRSmono jacks.• Pin layout: Tip=Hot Ring=Cold Sleeve=GNDW0 PGM1, 2 FADER output jacksConnect these jacks to the FADER input jacks ofDN-S3500, DN-S1200 and etc. using the 3.5mmstereo mini cord.W1 Phono ground screw (GND)• This screws provide a place to connect theground wire from a turntable.• This terminal is exclusively for a turntable groundand not a safety earth ground.W2 PHONO1, 2 / LINE1, 3 switches (LN / PH)• These switches change the input from PHONOto a LINE level input.• These switches set a LINE level input whenturntable is not connected.NOTE:Always be sure main power is shut off beforechange the position of the Line Level SelectorSwitch.W3 PHONO1, 2 / LINE1, 3 input jacksThese stereo pair of unbalanced RCA jacks areinputs for a PHONO (RIAA) stage for magnetic(MM) cartridges or a LINE stage suitable for anydevice, such as a CD player.W4 LINE2, 4 input jacksThese stereo pair of unbalanced RCA jacks areinputs for any line level device.W5 Unbalanced MASTER OUT jacks• This stereo pair of RCA jacks provides anunbalanced line level output.• Connect these jacks to the unbalanced analoginput jacks on an amplifier or console.W6 AC INInput connection for the included AC adaptor.NOTE:Use specified attached AC adaptor only.Front panelE1E0W9W8W8W7W7W7 CH 1/2 FADER START switchesUse this to switch the Channel Fader Startfunction ON and OFF.W8 CROSSFADER START A, B switchesUse this to switch the Crossader Start functionON and OFF.W9 CROSSFADER REVERSE switchReverses the direction of the crossfader.E0 CROSSFADER CONTOUR adjustmentAdjusts the shape of the crossfader curve froma fast cut for scratching or to a slow fade formixing.E1 HEADPHONE output jackAccept 1/4” stereo headphone plugs.Getting Started1.DN-X120_ENG.indd 7 2007/12/28 18:07:06