Denon DN-X120 Owner's Manual

Also see for DN-X120: Owner's manual Service manual Owner's manual Quick start guide

Contents

Denon DN-X120 Owner's Manual Manual pdf 8 page image

Getting Started Playback SpecificationsENGLISHNOTEAlways switch on your audio input sources suchas CD players first, then your mixer, and finally anyamplifiers. When turning off, always reverse thisoperation by turning off amplifiers, then your mixer,and then input units.Refer to the connection diagram below.1. Make certain AC power is off while makingconnections.2. Quality cables make a big difference in fidelityand punch. Use high-quality, audio cables.3. Do not use excessively long cables. Be sureplugs and jacks are securely fastened. Looseconnections cause hum, noise, or intermittentsthat could damage your speakers.4. Connect all stereo input sources. Then connectany effects into the stereo effect, if used. Connectyour microphone(s) and monitor headphones.Make sure all faders are at “zero” and the unit isoff. Take care to connect only one cable at a time.Pay attention to L and R position of jacks, on boththe DN-X120 and outboard gear.5. Connect the stereo outputs to the poweramplifier(s) and/or tape deck(s) and/or MDrecorder(s) and/or CD recorder(s). Plug the DN-X120 into AC power outlet.ConnectionsAudio cablesFor RCA PINJACKUnbalancedRLRLRCA pin pulagFor BALANCED MASTER OUTBalanced Balanced (1/4” TS)For MICBalanced (1/4” TRS) BalancedXLR3-11CFor BALANCED MASTER OUTBalanced Balanced (1/4” TS)XLR3-12CCables Used for ConnectionsSelect the cables according to the equipment beingconnected.PreparationsSleeve=GNDRing=ColdTip=HotSleeve=GNDRing=ColdTip=Hot1=GNDTurntable 2Main unbalanced power amplifierMain balanced power amplifier1/4” TRSmono jackTurntable 13.5 mm stereo mini cord3.5 mm stereo mini cordBalancedmicrophoneCD player1/4” TRS jackAC ADAPTORTo power outletCD playerAA-26: for AC 120VAA-27: for AC 230VAA-26 orAA-27NOTEUse specified attached AC adaptor only.Sleeve=GNDRing=ColdTip=Hot1=GND2=Hot3=Cold2=HotSleeve=GNDRing=ColdTip=Hot3=ColdConnectionsb The attached AC adaptor is exclusively for usewith this unit.Never connect to other devices.1.DN-X120_ENG.indd 8 2007/12/28 18:07:36