22ENGliShConnecting wireless LANUse this procedure to confi gure the wireless LAN settings.nSearch Access Point (Wireless LAN)1Fitting a rod antenna (vpage 6 “Connecting toa home network (LAN)”).•If a LAN cable is connected, remove it.2PressON/STANDBYto turn on power to the mainunit.3Press[MENU].Turns on the menu settings mode and the menu appears onthe display (vpage 20 “Menu map”).4Useuito select “Network” – “Connection” –“Search Access Point”, then press[ENTER],<1/3ENTER>orp.The access point you have set is displayed.5Useuito select the access point, and then press[ENTER],<1/3ENTER>orp.•If the access point is not detected automatically, confi gure itmanually (vpage 23 “Manual Settings”).6If there is an encryption setting for the access pointyou selected in step 5, enter same encryption key asused for the access point. (If there is no encryptionsetting, proceed to step 7.)Useuiopto input the “Key” (encryption key) and press[ENTER],<1/3ENTER>orp. Enter the same encryption keyas used for the access point.•The types of characters that can be input are as shown below.GLower case charactersHabcdefghijklmnopqrstuvwxyzG Upper case charactersHABCDEFGHIJKLMNOPQRSTUVWXYZGSymbolsH! “ # $ % & ‘ ( )z+ , - . / : ; < = > ? @ [ \ ] ^ _ ` { | }˜GNumbersH0123456789(Space)•WhennosecuritysettingshavebeenusedintheInternetconnection settings, this step is not necessary.nProxy settingsConfi gure these settings to connect to the internet via a proxyserver.1Press[MENU].Turns on the Menu settings mode and the Menu appears onthe display (vpage 20 “Menu map”).2Useuito select “Network” – “Connection” –“Proxy”, then press[ENTER],<1/3ENTER>orp.“Setup Proxy” menu appears.3If “Proxy(On)” appears, go to step 5.If “Proxy(Off)” appears, press[ENTER],<1/3ENTER>orp.“Select Proxy” menu appears.4Useuitoselect“On”,thenpress[ENTER],<1/3ENTER>orp.“Setup Proxy” menu appears.5Useuito select “Proxy (Address)” or “Proxy(Name)”, then press[ENTER],<1/3ENTER>orp.“Select Type” menu appears.6Useuito select “Address” or “Name”, then press[ENTER],<1/3ENTER>orp.“Setup Proxy” menu appears.7Useuito select “Address” or “Name”, then press[ENTER],<1/3ENTER>orp.“Input Proxy Address” or “Input Proxy Name” menu appears.8Useuipor[NUMBER] (0 – 9)to input the addressor name, then press[ENTER]or<1/3ENTER>.“Setup Proxy” menu appears.9Useuito select “Port”, then press[ENTER],<1/3ENTER>orp.“Input Proxy Port” menu appears.10Useuipor[NUMBER] (0 – 9)to input the port,then press[ENTER]or<1/3ENTER>.The Proxy settings are completed.Setting the network [Network]Button located on both the main unit and the remote controlBUTTONButton only on the main unitButton only on the remote control[BUTTON]Symbols used to indicate buttons in this manualuiopON/STANDBY<1/3ENTER>[ENTER][MENU]ON/STANDBY[NUMBER](0 – 9)uiop1.DNP720AEE2_ENG_Final_0727.indd222011/07/308:39:16