Connections ConnectionsENGLISH8142 3¢ AM loop antenna assemblyConnect to the AMantenna terminals.Remove the vinyl tieand take out theconnection line.Bend in the reversedirection.a. With the antenna ontop any stablesurface.b. With the antennaattached to a wall.MountInstallation hole Mount on wall, etc.NOTE:• Do not connect two FM antennassimultaneously.• Even if an external AM antenna is used, donot disconnect the AM loop antenna.• Make sure the AM loop antenna leadterminals do not touch metal parts of thepanel.Note to CATV system installer:This reminder is provided to call the CATVsystem installer’s attention to Article 820-40 ofthe NEC which provides guidelines for propergrounding and, in particular, specifies that thecable ground shall be connected to thegrounding system of the building, as close tothe point of cable entry as practical.Connection of AM antennas1. Push the lever.2. Insert the conductor.3. Return the lever.Connecting the XM terminal• DRA-37 is the XM Ready® receiver. You can receive XM® Satellite Radio by connecting to the XM Mini-Tuner and Home Dock (includes home antenna, sold separately) and subscribing to the XM service.• Plug the XM Mini-Tuner Home Dock into XM terminal on the rear panel.• Position the Home Dock antenna near a south-facing window to receive the best signal.For details, see “XM Satellite Radio” ( page 13).When making connections, also refer to the operating instructions of the XM Mini-Tuner and HomeDock.NOTE:• Keep the power supply cord unplugged until the XM Mini-Tuner and Home Dock connection havebeen completed.AUX OUTMXXM Mini-Tuner andHome Dock• The XM name and related logo are registered trademarks of XM Satellite Radio Inc. All rightsreserved.• XM Ready is a registered trademark of XM Satellite Radio Inc. All rights reserved.ENGLISH