ENTER17028+10394 5 6TOP MENU DISPLAYMARKERRANDOMPAGEA-BZOOMDIMMER PIC.ADJREPEATSETUPNTSC / PALCALL RETURNSKIP SLOW / SEARCHPOWERANGLE SUBTITLE AUDIO SEARCH MODEPLAYSTILL /PAUSESTOPPROG / DIRCLEARSRS.TSOPEN /CLOSERC-962ON OFFT. MENU DISP.MENU13ENGLISH6 REMOTE CONTROL UNIT2 The DVD-A11 can be controlled from a distance using the included remote control unit (RC-962).(1) Inserting Batteriesq Remove the remote control unit’s rear cover.w Place two R6P/AA batteries in the batterycompartment in the direction indicated by themarks.e Close the rear cover.Cautions On Batteries• Use R6P/AA batteries in this remote control unit.• Replace the batteries with new ones approximatelyonce a year, though this depends on the frequencywith which the remote control unit is used.• If the remote control unit does not operate fromclose to the main unit, replace the batteries withnew ones, even if less than a year has passed.• The included battery is only for verifying operation.Replace it with a new battery as soon as possible.• When inserting the batteries, be careful to doso in the proper direction, following the < and> marks in the remote control unit’s batterycompartment.• To prevent damage or battery fluid leakage:• Do not use a new battery with an old one.• Do not use two different types of batteries.• Do not short-circuit, disassemble, heat ordispose of batteries in flames.• Remove the batteries when not planning to usethe remote control unit for a long period of time.• If the batteries should leak, carefully wipe off thefluid from the inside of the battery compartment,then insert new batteries.(2) Using the Remote Control Unit30°30°Approx. 7 meters• When operating the remote control unit,point it at the remote control sensor asshown on the diagram.• The remote control unit can be used from adirect distance of approximately 7 meters.This distance will be shorter, however, ifthere are obstacles in the way or if theremote control unit is not pointed directlyat the remote control sensor.• The remote control unit can be operated ata horizontal angle of up to 30° with respectto the remote control sensor.NOTES:• It may be difficult to operate the remote control unit if the remote control sensor is exposed to direct sunlightor strong artificial light.• Do not press buttons on the main unit and on the remote control unit at the same time. Doing so will resultin malfunction.(3) Names and Functions of Remote Control Unit Buttons2 Button not explained here function in the same way as the corresponding buttons on the main unit.POWER ON/POWER OFFbuttonsPress this to switch the powerbetween on and standby.Number buttonsUse these to input numbers.Use the +10 button to inputnumbers of 10 or over.Example: To input 255+10 +10TOP MENU buttonThe top menu stored on the discis displayed.Cursor buttons/ENTER buttonUse the • and ª cursor buttonsto select in the vertical direction.Use the 0 and 1 cursorbuttons to select in thehorizontal direction.Press the ENTER button toselect the item selected withthe cursor buttons.MENU buttonThe DVD menu stored on thedisc is displayed.STOP button (2)SKIP buttonsANGLE buttonPress this to switch the angle.SUBTITLE buttonPress this to switch the DVD’ssubtitle language.A-B repeat button (A-B)Use this to repeat sectionsbetween two specific points.REPEAT buttonPress this to play tracksrepeatedly.SETUP buttonPress this to display the defaultsetting screen.DIMMER buttonUse this to adjust the brightnessof the main unit’s display. Canbe switched in 4 steps, fromOFF to always on.ZOOM buttonPress this to enlarge the image.Picture adjust button(PIC.ADJ)Press this to adjust the picturequality to suit your tastes.NTSC/PAL buttonUse this to switch the set’svideo output format (NTSC/PAL).OPEN/CLOSE buttonPROGRAM/DIRECT button(PROG/DIR)Press this to switch betweenthe normal play, programmedplay.CLEAR buttonPress this to clear numbers thatyou have input.SRS.TS buttonSets the virtual surround sound.(Functions when playing DVD-videos or VCDs only. (See page26.))RETURN buttonPress this to return to theprevious menu screen.DISPLAY buttonPress this to display the ON-SCREEN.CALL buttonPress this to check the programcontents.PLAY button (1)STILL/PAUSE button (3)SLOW/SEARCH buttonsSEARCH MODE buttonPress this to change the searchmode to search for groups ortitles, tracks or chapters whenselecting sections of discsdirectly using the numberbuttons.AUDIO buttonFor DVDs, press this to switchthe audio language. For videoCDs, press this to switch thechannel between “LR”, “L” and“R”.RANDOM buttonPress this to play the tracks onthe video or music CD in randomorder.MARKER buttonPress this to mark places youwant to see again.PAGE -/PAGE + buttonsUse these to selected thedesired still picture on DVDaudio discs containingbrowseable still pictures.