Denon FN-X1700 Owner's Manual

Contents

3Getting Started Connections Basic Operations Specifications TroubleshootingEffector Function Fader Start UtilityUSBPart Names and FunctionsFor further details on the functions and other aspects of the parts, refer to the page numbers inparenthesis.Top PanelR3E0W9W8W7W6W3W4W1Q9W0Q8Q7 Q6 E9R0Q4Q5Q3Q2Q0Q1uioE8ryE6ewqR2R1E5E2E3E1E4tW2W5E7q MASTER LEVEL controlAdjusts the level of the MASTER outputs.The LIMITER LED indicates the operating statusof the master output limiter.• Limiter OFF: LED is off.• Limiter ON: LED lights up green.• While limiter is operating: LED lights up red.w Master EFX INS 1, 2 buttonsThese buttons enable the various effects ofthe selected side, either EFX 1 or EFX 2, to beobtained for the master output signals.e BOOTH LEVEL controlAdjusts the level of the BOOTH outputs.r USB ASSIGN CH/MASTER buttonThis is used to switch the assignment destinationof the USB audio input signals supplied from thecomputer.CH:The signals are assigned to the channels (1 to 4).MASTER:The signals are assigned to the master bus andmonitor bus.t MIDI CLOCK START/STOP buttonThis enables the MIDI clock corresponding tothe BPM value to be sent from the USB MIDIand MIDI output terminals to the computer(software) or external device.START:Sending the MIDI clock is started.STOP:Sending the MIDI clock is stopped.y UTILITY/–USB A/USB B buttonThis allows the presets to be set and the systeminformation to be set, changed or referenced.When it is held down for more than a second,the USB mode switching screen is opened, andthe USB device mode or USB host mode canbe selected.u BEAT , buttons(Short) :The beat/time is decreased.(Long) :The beat/time is increased.i TAP LOCK/AUTO/INPUT BPM buttonTAP:When this button is tapped repeatedly, the BPM(Beats Per Minute) value is measured using theintervals between the taps.LOCK:When the button is pressed once in the auto BPMmode, the BPM value measured automatically islocked.AUTO BPM:When the button is held down for one second,the auto BPM mode is established, and themeasured BPM value is displayed.INPUT BPM:When it is held down for two or more seconds,the BPM input mode is established, and theBPM value can be input directly using theu BEAT , buttons. When it is pressedagain, the mode is released.o TIME/BACK buttonTIME:This button is used to select whether to changethe effects produced using the u BEAT ,buttons on the basis of the number of beatsor time.BACK (EFX 2 side only):This is used when returning to the previousscreen while setting screen operations arebeing performed.Q0 Effect CUE buttonWhen this button is set to ON, the sound of theeffects (but not the DELAY, ECHO or REVERBeffects) can be monitored even if the effect OFFstatus.Q1 EFX SELECT controlThis is for selecting the effect to be used.Refer to the effect functions (page 9).Q2 Parameter ON/OFF buttonThis is used to control the ON and OFF settingsof the effect parameters.Q3 PARAMETER MIX/MAX controlThis is used to adjust the filter cutoff frequencyand other effector parameters. The parametersare changed by the effector selected.Q4 DRY/WET controlUse this to adjust the ratio of original andeffected sound.Getting Started