Changing the Speaker’s Equalizer1 Select “EQ”.2 Adjust the Treble or Bass up or down.NOTESelect the Reset button to restore the default settings.Changing the Speaker’s Orientation(HEOS 3 Only)The HEOS 3 can be placed both vertically and horizontally.Each orientation has it’s own sound tuning and should be set accordinglyfor optimal sound quality.1 Select “Orientation”.2 Select “Vertical” if you placed your HEOS 3 vertically orselect “Horizontal” if you placed your HEOS 3horizontally.3 Select the Back button and your settings areautomatically saved.Adjusting the Audio QualitySelects the transcoding option for rebroadcasting audio from one HEOSdevice to another HEOS device (or group of devices) across the network.When set to “Normal”, high bit rate audio sources originating from the firstdevice (such as AUX input, WAV, FLAC and PCM) will be transcoded toensure the highest level of reliability for the audio stream.1 Select “Quality”.2 Select Normal (default) or High.0 If you have selected High and you experience audio dropouts when streamingsources from one device to other devices, please select Normal (default).0 This setting does not affect the AUX input when played on the connected deviceby itself (there are no other devices grouped to it), in which case the originalsource quality and bit rate are maintained and there is no inherent delay.Adjusting the Status Light Brightness1 Select “Status Light”.2 Adjust the brightness up or down or set the slider tothe OFF position to completely disable the status light.Contents Setup Use Troubleshooting Status LED Appendix38