Denon HEOS Drive Owner's Manual

Also see for HEOS: Quick start guide Quick start guide Owner's manual Owner's manual Quick start guide

Contents

Denon HEOS Drive Owner's Manual Manual pdf 15 page image

o Connecting Speakers (Two Bridged Zones)Larger output can be obtained by connecting using a bridgedconnection.1 Turn off the power switch of rear panel.2 Connect speakers to the adjacent gray colored speakerterminals between zones 1 and 2 OR zones 3 and 4.3 Slide the Bridge switch to the “ON” position. .(L)wqwq(R)NOTE0 Turn off the power switch of rear panel before connecting the speakers. Also, turnoff the subwoofer.0 Connect so that the speaker cable core wires do not protrude from the speakerterminal. The protection circuit may be activated if the core wires touch the rearpanel or if the + and – sides touch each other.0 Never touch the speaker terminals while the power cord is connected and powerswitch of rear panel is turned on. Doing so could result in electric shock.0 Use speakers with an impedance of 4 – 16 Ω/ohms. The protection circuit may beactivated if speakers with an impedance other than specified are used.0 In BRIDGE mode, one channel is output from one ZONE. In the example shownhere, no signal is output from the speaker Rch of ZONE1 and Lch of ZONE2.0 Zones 1 and 2 connected using a bridge connection operate as Zone 1, andZones 3 and 4 connected using a bridge connection operate as Zone 3.0 When a bridge connection is used, Zone2/Zone4 are not displayed in “Roomsview”. To display as Preamp Out, refer to “Adjusting the PreampOut” (v p. 39).Contents Setup Use Troubleshooting Status LED Appendix15