Adjusting the Output Mode1 Select “Output Mode”.2 Select Stereo or Dual Mono.Adjusting the Audio QualitySelects the transcoding option for rebroadcasting audio from one HEOSdevice to another HEOS device (or group of devices) across the network.When set to “Normal”, high bit rate audio sources originating from the firstdevice (such as AUX input, WAV, FLAC and PCM) will be transcoded toensure the highest level of reliability for the audio stream.1 Select “Quality”.2 Select Normal (default) or High.If you have selected High and you experience audio dropouts when streamingsources from one device to other devices, please select Normal (default).Adjusting the Volume LimitYou can set the maximum volume of the HEOS Drive amplifiers to preventsudden loud volume.1 Select “Volume Limit”.2 Select the maximum volume percentage (95, 90, 85,80).Adjusting the Preamp OutZONE2 and ZONE 4 “Volume limit” will change to “Preamp Out”, when youset the Bridge switch to “ON”.1 Select “Preamp Out”.2 Select Disabled or Enabled.Disabled(Default):PRE OUT is disabled and does not appearedin Rooms view.Enabled: PRE OUT is enabled and Zone Nameappeared in Rooms view.Contents Setup Use Troubleshooting Status LED Appendix39
