Denon PMA-2020AE Owner's Manual

Also see for PMA-2020AE: Getting started Service manual

Contents

Denon PMA-2020AE Owner's Manual Manual pdf 8 page image

5Connecting the speakersSpeaker A/B connection• The same signal is output from the SYSTEM (A) and (B) terminals.• When only one set of speakers is to be connected, use either the SYSTEM (A) or (B) terminals.w qw q(R)(L)w qw q(R)(L)Speakers A Speakers BSpeaker impedanceUse speakers with impedances within the ranges shown below to suit how they are used.Speakers used ImpedanceA or B 4 – 16 ΩA and B 8 – 16 ΩBi-wiring connection 4 – 16 ΩProtection circuitThe protection circuit is be activated in the following situations:• If the speaker cable wire touches the rear panel or screws or if the speaker cable wire touches thespeaker cable’s + and – sides are touching• If the surrounding temperature is extremely high• If the inside of the amplifier gets hot to extended use at a high outputIf this happens, unplug the power cord, then check the connections of the speaker cables and input cables.If the unit becomes very hot, wait for it to cool off and improve the ventilation around it. After doing this,plug the power cord back in.If the protection circuit is activated even though there are no problems with the ventilation around the unitor in connections, the unit may be damaged. Turn off the power and then contact a DENON service center.