Denon PMA-50 Owner's Manual
Also see for PMA-50: Quick start guideQuick start guideService manualQuick start guide
                                                                                             | |
Contents
|
9 Checking audio output.Outputs a TEST signal from the PC and checks the audio outputfrom the USB-DAC function.A Select “Digital Audio Interface” and click “Properties”.0 The Digital Audio Interface Properties window is displayed. .PropertiesSelect a playback device below to modify its settingsSoundConfigureConfigure Set DefaultSet DefaultPlayback Recording CommunicationsSoundsSelect a playback device below to modifyqB Click the “Advanced” tab.C Select the sampling rate and bit rate to be applied to the D/Aconverter.0 It is recommended that “2 channel, 24 bit, 192000 Hz (StudioQuality)” is selected.D Click “Apply”.E Click “Test”.0 Check that audio from this unit is output from the PC. .ApplyCancelTestOK2 channel, 24 bit, 192000 H Studio QualityGive exclusive mode applications priorityDefault FormatSelect the sample rate and bit depth to be used when runningin shared mode.Digital Audio Interface PropertiesAllow applications to take exclusive control of this deviceApplyRestore DefaultsRestore DefaultsGeneral Supported Formats Levels Advanced2 channel, 24 bit, 44100 H Studio Quality2 channel, 24 bit, 48000 H Studio Quality2 channel, 24 bit, 96000 H Studio Quality2 channel, 24 bit, 192000 H Studio QualitywertNOTE0 The dedicated driver must be installed in the PC before this unit is connected to aPC. Operation will not occur correctly if connected to the PC before the dedicateddriver has been installed.0 Operation may fail in some PC hardware and software configurations.Contents Connections Playback Setting procedure Tips Appendix32Front panel Display Rear panel Remote Index |
Related manuals for Denon PMA-50
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine