Denon RCD-M35DAB Operating Instructions Manual

Also see for RCD-M33: Specification Operating instructions Operating instructions Service manual Operating instructions

Contents

Denon RCD-M35DAB Operating Instructions Manual Manual pdf 5 page image

5RCD-M35DABDRR-M33DRR-M33 RCD-M35DAB5 CONNECTIONSConnecting the speaker systemsConnect the speaker system for the left channel (the left side as seenfrom the front) to the L terminals, the speaker system for the rightchannel to the R terminals. Refer to the instructions supplied with thespeaker system for details. Be sure to use speaker systems with animpedance of 6 Ω/ohms or greater.NOTE:• This system includes digital circuitry whichmay cause interference such as colorblotching or changes in the color on TVs. Ifthis happens, move the system and theTV as far apart as possible.NOTES:• Do not plug the power cord into the power outlet until all connections are completed. Besure to interconnect the channels (L to L (white) and R to R (red)) properly, as shown on thediagram.• Insert the plugs securely. Incomplete connections may result in noise.• Be sure to connect the speaker cords between the speaker terminals and the speakersystems with the same polarities ( + to +, – to – ). If the polarities are switched, the sound atthe center will be weak, the position of the different instruments will be unclear, and thestereo effect will be lost.• After unplugging the power cord, wait about 5 seconds before plugging it back in.• Note that setting the connection cords (pin-plug cords) next to the power cords may result inhumming or other noise.CAUTION:• Whenever the power operation switch is in the STANDBYposition, the unit is still connected to AC line voltage.Please be sure to unplug the power cord when you leave homefor, e.g.,a vacation, etc.System operationsSuch system operations as the timer and the auto power on functions, as well as remote controloperations cannot be performed unless all the RCA pin-plug cords and system connector cordsare connected between the units, so be sure to make all the connections properly as shown inthe diagram. Also, disconnecting system connectors while the system is operating may result inmalfunctions. Be sure to unplug the power cord before changing connections.Install the sets as shown in oneof these diagrams. In eithercase, be sure that the CDreceiver’s ventilation holes arenot obstructed.(1) Connecting to Cassette deck (DRR-M33)FM antennaAM loop antennaRightSubwooferLeftPower plugAC 230 V, 50 HzSide by side installationStacking installation(option)Cassette deck(DRR-M33)CD receiver (RCD-M35DAB/RCD-M33)Right LeftSpeaker systems (SC-M53)DAB antenna(RCD-M35 only)Speaker systems (SC-M73)(RCD-M35 only)