Denon RCD-M39 Owner's Manual

Also see for RCD-M39: Getting started guide Owner's manual Service manual Service manual Getting started

Contents

14Presetting FM stations manuallyThis unit can be preset with a total of 40 FM broadcast stations.1 Tune in the station you want topreset.2 Press ENTER.The minimum number display “P– –” forthe unregistered preset flashes.3 Use 0 – 9, +10 or CHANNEL –, +to select the number to be preset,then press ENTER.The reception frequency and receptionmode are preset and the displayswitches to the station name inputdisplay.NOTEWhen the registered preset number isselected, “*” is displayed.To overwrite this preset number, pressENTER.4 Input the station name.Names of up to 8 characters can be input.• u, i button ..................... Selects the character.• p button .......................... Moves the cursor to the right.• CLEAR button ................... Deletes the currently selectedcharacter.• Characters that can be input.A ~ Z, 0 ~ 9, ^ ’ ( ) z + , - . / = (space)• If you do not want to input a station name, press ENTER withoutinputting anything else.• If you make a mistake when inputting, perform the procedureagain. Whatever was previously input is overwritten.5 Press ENTER.The characters you have input are entered.• To give names to other stations, repeat steps 1 to 5.Listening to preset stationsUse 0 – 9, +10 or CHANNEL –, + toselect the preset number.Listening to FM broadcastsSetting the preset channels and changingthe received frequency on the main unit8/–, +/9 on the main unit can be used both for switching thepreset channel and for tuning.Before operating them, switch the main unit to the “preset mode” or“tuning mode” using the procedure below.1 Press SETUP.2 Use ui to select “TUNERSETUP”, then press ENTER orp.3 Use ui to select “MODESELECT”, then press ENTER orp.4 Use ui to select “PRESETMODE” or “TUNING MODE”,then press ENTER.PRESET MODE Press 8/–, +/9 on the main unit to switchpreset channels.• This is the same operation as CHANNEL –, +on the remote control unit.TUNING MODE Press 8/–, +/9 on the main unit tochange the received frequency.• This is the same operation as TUNE–, + on theremote control unit.