Speaker connectionHere we connect the speakers in the room to this unit.This section explains how to connect them using typical examples.NOTE0 Disconnect this unit’s power plug from the power outlet before connecting thespeakers. Also, turn off the subwoofer.0 Connect so that the speaker cable core wires do not protrude from the speakerterminal. The protection circuit may be activated if the core wires touch the rearpanel or if the + and - sides touch each other. (“Protection circuit” (v p. 68))0 Never touch the speaker terminals while the power cord is connected. Doing socould result in electric shock.0 Use speakers with an impedance of 6 – 16 Ω/ohms.Connecting the speaker cablesCarefully check the left (L) and right (R) channels and + and – polarities onthe speakers being connected to this unit, and be sure to connect thechannels and polarities correctly.1 Peel off about 3/8 inch (10 mm) of sheathing from thetip of the speaker cable, then twist the core wire tightly. .2 Turn the speaker terminal counterclockwise to loosenit. .3 Insert the speaker cable’s core wire to the hilt into thespeaker terminal. .4 Turn the speaker terminal clockwise to tighten it. .Contents Connections Playback Settings Tips Appendix18Front panel Display Rear panel Remote Index