Desa A Series Owner's Operation And Installation Manual

Contents

11104410OWNER’S MANUALAUTOOFFON321Figure 17 - Wire AttachmentFigure 18 - Installing BushingsBushing Locationfor RecessedInstallationBushingLocation forFreestandingInstallationBlueWireRed WireGreenWireBlack WireWhiteWireBlueWireTo Switch andCover AssemblyNote: To prevent shortcircuit, white wire MUSTbe connected to motor.15. Peel off the backing paper and stick thesupplied wiring diagram decal on thefirebox bottom approximately 12" infront of blower.Note: If any of the original wire as suppliedwith the appliance must be replaced, it mustbe replaced with 105˚C wire or it's equivalent.WARNING: Failure to posi-tion the parts in accordance withsupplied diagrams or failure touse only parts specifically ap-proved with this heater may re-sult in damage or personal injury.Figure 19 - Wiring DiagramBlueBlueFan Switch(Off/On/Auto)Red FanSwitch(N.O.)GreenWhiteOn110/115V.A.C.BlowerMotorBlackOff123AutoINSTALLATIONContinued16. Replace log base assembly in fireplace.Feed flexible gas supply line into fire-place base area while replacing log baseassembly. Make sure the entire flexiblegas line is in fireplace base area.Note: If firebrick is installed, make surethe back of the firebox bottom slidesunder the rear panel of the firebrick (liftthe firebrick up if necessary.IMPORTANT: Do not pick uplog base assembly by burners.This could damage burners. Onlyhandle base by grates.17. Reattach log base assembly to fireplacewith screws removed in step 1, page 10.Continued13. Plug in blower power cord.If your fireplace system is installedas a freestanding unit with an acces-sory mantel, install one plastic bush-ing (provided) into the 1.5" hole in thelower left side of the outer casing (seeFigure 18). Route power cord throughplastic bushing. Plug the power cordinto a properly grounded three-prongwall receptacle near the firebox.If your fireplace system installationis recessed, install one plastic bushingprovided into the 1.5" hole near themiddle of the left floor support bracket(see Figure 18). Route power cordthrough plastic bushing. Plug the powercord into a properly installed duplexoutlet. (If an outlet is not available, theaccessory model GA3555 Outlet Kitwith cover can be installed in your fire-place. This will supply a convenientthree-prong grounded electrical outletfor your blower. Refer to the installa-tion manual provided with the modelGA3555 accessory for instructions onwiring the duplex outlet.)14. Check to make sure that the power cordand wires are completely clear of theblower wheel and that there are no otherforeign objects in blower wheel. Turnblower on by pushing the selector switchto the on position and check for opera-tion. Turn blower off before continuing.WARNING: Never touch theblower wheel while in operation.