Desa A Series Owner's Operation And Installation Manual

Contents

9104410OWNER’S MANUAL6. Plug in blower power cord.a. If your fireplace system is installedas a freestanding unit with an ac-cessory mantel, determine whetherthe power cord will exit the left sideor the right side of the firebox. In-stall 1 plastic bushing provided intothe 1.5" hole in the floor supportbracket on the exit side (see Figure11). Install the second plastic bush-ing provided into the 1.5" hole in theouter casing through which thepower cord will exit. Route powercord through both plastic bushingsand plug the power cord into a prop-erly grounded 3-prong wall recep-tacle near the firebox.b. If your fireplace system installa-tion is recessed, plug the power cordinto a properly installed duplex out-let. (If an outlet is not available, theVanguard accessory model GA3555Outlet kit with/ cover can be installedin your fireplace which will supplya convenient 3-prong grounded elec-trical outlet for your blower. Referto the installation manual providedwith the model GA3555 accessoryfor instructions on wiring the duplexoutlet.)7. Check to make sure that the power cordis completely clear of the blower wheeland that there are no other foreign ob-jects in blower wheel. Turn blower onand check for operation. Turn bloweroff by rotating knob fully counterclock-wise before continuing.WARNING: Never touch theblower wheel while in operation.8. Peel off the backing paper and stick thesupplied wiring diagram decal on the fire-box bottom approximately 3" to the rightof the blower speed control (Figure 12).Figure 11 - Installing Plastic Bushing forPower CordPlasticBushingRight FloorSupportBracketVariableFan SwitchWhiteWhiteBlackGreenOn110/115V.A.C.BlowerMotorBlackBlackBlackOffFigure 12 - Location of Wiring Diagram Decal3" from BlowerWiringDiagramWARNING ICON G 001 WARNINGNever attempt to service heater while it is plugged in,operating, or hot. Burns and electrical shock couldresult. Only a qualified service person should serviceor repair heater.If any of the original wire as supplied with the appliance must bereplaced, it must be replaced with 105°C wire or it’s equivalent.101584-05120 Vac. 60 Hz. . 78 AmpsDESA International, Bowling Green, KYINSTALLATIONContinued9. Replace log base assembly in fireplace.Feed flexible gas supply line into fire-place base area while replacing log baseassembly. Make sure the entire flexiblegas line is in fireplace base area.Note: If firebrick is installed, makesure the back of the firebox bottomslides under the rear panel of the fire-brick. (lift the firebrick up if necessary.)CAUTION: Do not pick up logbase assembly by burners. Thiscould damage burners. Onlyhandle base by grates.VariableFan SwitchWhiteWhiteBlackGreenOn110/115V.A.C.BlowerMotorBlackBlackBlackOff10. Reattach log base assembly to fireplacewith screws removed in step 1.Note: Discard the remaining hardware items.WARNING: Failure to positionthe parts in accordance with sup-plied diagrams or failure to useonly parts specifically approvedwith this heater may result in dam-age or personal injury.Continued