116170-01A 5www.desatech.comASSEMBLY(FOR 40, 55 AND 70 MODELS ONLY)These models are furnished with a nose coneguard. Nose cone guard and mounting screws arefound in the shipping carton.Tools Needed• 5/16" nut driver or wrench1. Place nose cone guard on top of upper shellflange. Make sure nose cone guard is on hotair outlet end of heater.2. Insert screws through nose cone guard andupper shell flange.3. Tighten screws firmly.Figure 7 - Wheel and Handle Assembly,115/165 Models OnlyWheel SupportFrameFuelTankFlangeCap NutWheelNutAxle ExtendedHubAirInletHandle (Ifprovided)Hot AirOutletScrewWheel Spacer(If Provided)Cord Cleat with Boltsand Nuts (If provided)Handle(FOR 115 AND 165 MODELS ONLY)These models are furnished with wheels and ahandle. Some models are furnished with a secondhandle also. Wheels, handle(s), and the mountinghardware are found in the shipping carton.Tools Needed• Medium Phillips Screwdriver• 3/8" Open or Adjustable Wrench• Hammer1.Slide axle through wheel support frame. Installwheel spacers if provided. Install wheels on axle.IMPORTANT: When installing wheels, pointextended hub of wheels toward wheel supportframe (see Figure 7).2. Place cap nuts on axle ends. Gently tap withhammer to secure.3. Place heater on wheel support frame. Line upholes on fuel tank flange with holes on wheelsupport frame. Be sure wheels are mountedunder the air inlet of heater.4. Place handle(s) on top of fuel tank flange. In-sert screws through handle(s), fuel tank flange,and wheel support frame. Attach nut fingertight after each screw is inserted. If only onehandle is provided, be sure to mount handleover outlet end of heater.5. After all screws are inserted, tighten nutsfirmly.Figure 6 - Nose Cone Guard Assembly,40/55/70 Models OnlyNose ConeGuardScrewHot AirOutletUpper ShellFlange