Desa CGEFP33NRB Owner's Operation And Installation Manual

Also see for CGEFP33NRB: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

111245-01AFor more information, visit www.desatech.comFor more information, visit www.desatech.com99Figure 6 - Removing Fireplace Floor AssemblyScrewsFireplace FloorAssemblyFlexible Gas LineINSTALLATIONContinuedELECTRICAL CONNECTIONS FOR POWERCORDThis fireplace operates on 120 VAC, 60 Hz power. An electricalpower cord is supplied with this unit.For Mantel Installation1. Determine from which side of the fireplace the power cord willexit. Locate the 1.5" diameter hole near the center of floor sup-port bracket on appropriate side of lower cavity (see Figure 7).2. Locate power cord. Remove wire tie or tape holding plug endof power cord.3. Power cord has 2 plastic hole bushings threaded onto it. Routecord's 3-prong plug through the 1.5" diameter hole in appro-priate floor support bracket.4. Push first plastic bushing completely through hole. Squeezebushing as needed to do this.5. Install the second plastic bushing into the hole in the floor sup-port bracket by snapping into place.6. Route the 3-prong plug through the 1.5" hole in fireplaceouter casing.7. Install the first plastic bushing into this hole by snapping into place.8. After you have connected to gas supply and checked your gasconnections (see pages 15 through 18), plug power cord intoany convenient 3-prong grounded wall receptacle near fireplace.For Recessed InstallationIf an outlet is not installed in fireplace, install model GA3555 -Outlet Kit with Cover. This kit will supply a convenient 3-pronggrounded electrical outlet for power. Refer to installation manualprovided with this optional accessory for instructions on wiring.Note: A qualified installer must make all electrical connections.Figure 7 - Routing Power CordPower CordBushingsHole in FloorSupport Bracket Hole in OuterCasingRELOCATING WALL SWITCH ASSEMBLYNote: The decorative wall switch plate supplied is white. The wallswitch plate may be painted to match your decor.The push-button switch and decorative wall plate assembly sup-plied with your fireplace is pre-mounted at the factory in the lowercavity of the fireplace. You may relocate this wall switch assemblyto a more convenient location such as the side of your mantel ordirectly onto the wall near the fireplace. To mount the wall switchassembly, you must first cut openings in the mantel or wall wherethe switch will be located.Note: If you choose to relocate the wall switch assembly, do sobefore final installation into a mantel or recessing into a wall. If youare installing an optional blower accessory, install it at the same timeyou relocate the wall switch assembly.For Recessed InstallationIf fireplace is to be recessed into a wall (see Built-In FireplaceInstallation, pages 19 and 20), we recommend mounting wallswitch assembly to left side of fireplace. The wall switch assemblyshould be mounted approximately 12" from left edge of fireplace,and less than 60" from the floor.IMPORTANT: Do not locate wallswitch assembly directly in front of wall stud - there must be roombehind wall board for wires from switch. If you choose to locate wallswitch assembly to right side of fireplace, the length of the cordrestricts you to less than 6" from right edge of fireplace and less than48" from floor.CAUTION: The wall switch assembly must neverbe mounted directly above the fireplace where heatmay damage it. If you relocate wall switch assemblyfrom lower fireplace cavity, it must be mounted eitheron side wall of mantel or on wall to side of fireplace.INSTALLATIONRemoving Fireplace Screen And Floor Assembly (Cont.)Electrical Connections for Power CordRelocating Wall Switch Assembly