Desa CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB Owner's Operation And Installation Manual

Also see for CGEFP33NRB: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

www.desatech.com 111245-01B26NORMAL LIGHTINGINSTRUCTIONSWARNING: You must oper-ate this heater with the fireplacescreen in place. Make sure fire-place screen is in place beforerunning heater.NOTICE: During initial operation ofnew heater, burning logs will giveoff a paper-burning smell. Opendamper or window to vent smell.This will only last a few hours.1. STOP! Read the safety information onpage 25.2. Make sure equipment shutoff valve isfully open.3. Wait five (5) minutes to clear out any gas.Smell for gas around heater and near floor. Ifyou smell gas, STOP! Follow “B” on page 25.If you donʼt smell gas, go to the next step.A. Using Supplied Wall Switch Assembly1. Set manual ignition bypass switch on thecontrol panel to the OFF position (auto-matic ignition position).2. Press ON/OFF button. Hold for 6 seconds.Gas valve will open and electronic ignitionwill begin sparking to light pilot. LED willlight. Note: You may be running this heaterfor the first time after connecting to gas sup-ply or at the start of your heating season.If so, the ON/OFF button may need to bepressed again. This will allow air to bleedfrom gas system. If several attempts to lightpilot fail, contact a qualified service personor gas supplier for repairs. Until repairsare made, light and operate manually (seeManual Lighting Instructions for ElectricPower Outage, page 27).3. When pilot flame is lit, the thermocouple isheated by the flame. When thermocouplebecomes hot (5 to 15 seconds), main burnerwill automatically light on high flame.4. To lower flame, push HI/LO button on wallswitch once. Note: This fireplace does nothave a pilot-only mode.OPERATING FIREPLACEContinuedFigure 47 - Control LocationsManual Ignition Bypass Switch(Up is for Remote Control)ON/OFFButtonHI/LOButtonWallSwitchAssemblyLEDAutomaticIgnitorElectrodeFigure 48 - Pilot (Natural Gas)Manual IgnitorElectrodeFigure 49 - Pilot (Propane/LP Gas)AutomaticIgnitorElectrodePilotBurnerManual IgnitorElectrodePilotBurnerB. Using Hand-Held Wireless RemoteControl1. Set manual ignition bypass switch oncontrol panel to OFF position (automaticignition position).2. Wait five (5) minutes to clear out any gas.Smell for gas around heater and near floor.If you smell gas, STOP! Follow “B” on page25, column 2. If you donʼt smell gas, go tothe next step.3. Point remote control toward the lowerfront of fireplace and push both buttonsat the same time. Hold for 6 seconds. Thegas valve will open and electronic igni-tion will begin sparking to light the pilot.Note: You will be able to hear a clickingsound during this process. LED on wallswitch will light.CAUTION: Do not try to ad-just heating levels by using theequipment shutoff valve.