www.desatech.com111245-01C 23Figure 37 - Minimum Mantel Clearancesfor Built-In InstallationSuppliedFireboxHoodMust BeUsed atAll TimesWire-meshScreenFireboxNoncombustibleMaterial MayProject Off thisSurface abovethe FireboxHoodMantel Shelf13" 16" 19" 21"2 1/2"6"8"10"Note: All verticalmeasurements arefrom top of fireplacehood opening tobottom of mantelshelf. These minimumclearances replace anyother recommendedclearances suppliedwith your ANSI Z21.11.2approved gas logs.Wall board or facingmaterial (abovefirebox) may be ofcombustible material,including decorativemantel ornaments orother similar projec-tions off of the facingmaterial. FramingMaterialINSTALLATIONContinuedASSEMBLING AND ATTACHINGOPTIONAL BRASS TRIM(Included with Mantel Accessory)Note: The instructions below show assemblingand attaching brass trim to fireplace.1. Remove packaging from three pieces ofbrass trim.2. Locate four brass screws, two adjustingplates with set screws and two shims in thehardware packet.3. Align shim under adjusting plate as shown inFigure 38.4. Slide one end of adjusting plate/shim in slot onmitered edge of top brass trim (see Figure 38).5. Slide other end of adjusting plate/shim in slot onmitered edge of side brass trim (see Figure 38).6. While firmly holding edges of brass trim to-gether, tighten both set screws on the adjustingplate with slotted screwdriver.7. Repeat steps 1 through 6 for the other side.8. Tighten trim hanging screws (#10 x 6.25shoulder) into holes in cabinets. Place theassembled trim onto fireplace cabinet. Alignhanging notches on trim with hanging screwson side of fireplace (see Figure 39). Push trimfirmly into place, sliding hanging notches overhanging screws.Figure 38 - Assembling Brass TrimSlotMitered EdgeSlotShimSet ScrewsAdjustingPlateSide BrassTrimTop Brass TrimFigure 39 - Attaching Brass Trim toFireplaceTrimHangingScrewsAssembledBrass TrimHangingNotcheson TrimFigure 40 - Installing Hood to FireboxINSTALLING HOODInstall hood to top of firebox as shown in Figure 40.Use 3 Phillips screws provided.