www.desatech.com111245-01C 25Figure 44 - Installing CrossoverLogs (#4 & #5) [CGEFP Logs Shown]PinsCrossoverLog (#5)CrossoverLog (#4)INSTALLING BATTERY INTOREMOTE1. Locate slot at bottom of remote control (seeFigure 45). Firmly insert tool such as a smallscrewdriver, butter knife or dime into the slotand lift up to remove cover.2. Insert supplied battery into remote control.Positive and negative are marked inside re-mote control casing. Note: Remote will notfunction if battery is not installed correctly.3. Slide tab on cover into remote housing andsnap cover back into place.IMPORTANT: Use only A23 12 volt battery inremote. DO NOT use AAA battery.PositiveFigure 45 - Installing BatteryNegativeTabCoverRemoteControlSlotA23 12Volt BatteryFigure 46 - Installing Fireplace ScreenINSTALLING SCREENInstall fireplace screen by slipping notches offireplace screen over screws on front of fireplace(see Figure 46).NotchesScrews forMountingScreenINSTALLATIONContinuedOPERATING FIREPLACEFOR YOUR SAFETYREAD BEFORE LIGHTINGWARNING: If you do not fol-low these instructions exactly,a fire or explosion may resultcausing property damage, per-sonal injury or loss of life.A. This appliance has a pilot which lights auto-matically when using the supplied wall switchor remote control. If you have a power outage,the pilot may be lighted by hand with push-button piezo ignitor. When lighting the pilot,the following warnings must be followed.B. BEFORE LIGHTING smell all around theappliance area for gas. Be sure to smell nextto the floor because some gas is heavier thanair and will settle on the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; do notuse any phone in your building.• Immediately call your gas supplier froma neighbor’s phone. Follow the gassupplier’s instructions.• If you cannot reach your gas supplier, callthe fire department.C. Electric Power Outage Only: Use only yourhand to turn the manual override handleon the gas control knob. Never use tools. Ifthe knob will not turn by hand, don’t try torepair it, call a qualified service technicianor gas supplier. Force or attempted repairmay result in a fire or explosion.