Desa CRB3624NR Owner's Operation And Installation Manual

Also see for CRB3624NR: OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

Desa CRB3624NR Owner's Operation And Installation Manual Manual pdf 22 page image

www.desatech.com 120044-01D22FRONT BURNER FLAME PATTERNFigure 32 shows correct front burner flamepattern. Figure 33 shows incorrect frontburner flame pattern. The incorrect burnerflame pattern shows yellow tipping at top ofblue flame.WARNING: If yellow tippingoccurs, your heater could pro-duce increased levels of carbonmonoxide. If front burner flamepattern shows yellow tipping,follow instructions at bottom ofthis page. Yellow flame on rearburner is normal.NOTICE: Do not mistake orangeflames with yellow tipping. Dirtor other fine particles are burnedby heater, causing brief patchesof orange flame.INSPECTING BURNERSContinuedFigure 32 - Correct Front Burner FlamePatternFigure 33 - Incorrect Front Burner FlamePatternYellow Tipping AtTop of Blue FlameCLEANING AND MAINTENANCEIf front burner flame pattern is incorrect, asshown in Figure 33• turn heater off (see To Turn Off Gas to Ap-pliance, page 19)• see Troubleshooting, page 24WARNING: Turn off heaterand let cool before cleaning.CAUTION: You must keepcontrol areas, burners andcirculating air passagewaysof heater clean. Inspect theseareas of heater before each use.Have heater inspected yearlyby a qualified service person.Heater may need more frequentcleaning due to excessive lintfrom carpeting, pet hair, beddingmaterial, etc.WARNING: Failure to keepthe primary air opening(s) ofthe burner(s) clean may result insooting and property damage.BURNER INjECTOR HOLDER ANDPILOT AIR INLET HOLEThe primary air inlet holes allow the properamount of air to mix with the gas. This pro-vides a clean burning flame. Keep theseholes clear of dust, dirt, lint and pet hair.Clean these air inlet holes prior to eachheating season. Blocked air holes will createsoot. We recommend that you clean the unitevery three months during operation andhave heater inspected yearly by a qualifiedservice person.We also recommend that you keep the burnertube and pilot assembly clean and free of dustand dirt. To clean these parts we recommendusing compressed air no greater than 30 PSI.Your local computer store, hardware store orhome center may carry compressed air in acan. If using compressed air in a can, pleasefollow the directions on the can. If you don’tfollow directions on the can, you could dam-age the pilot assembly.1. Shut off unit, including pilot. Allow unit tocool for at least thirty minutes.