Desa Comfort Glow CGD3924P Owner's Operation And Installation Manual

Desa Comfort Glow CGD3924P Owner's Operation And Installation Manual Manual pdf 21 page image

21102991OPERATINGHEATERManually-Controlled ModelsContinuedTO TURN OFF GAS TO APPLIANCEShutting Off Heater1. Press in and turn control knob clockwise Clockwise to the HIGH position.2. Turn control knob clockwise Clockwise to the pilot position.3. Press in control knob and turn clockwise Clockwise to the OFF position.Shutting Off Burners Only (pilot stays lit)1. Turn control knob clockwise Clockwise to the HIGH position.2. Press in and turn control knob clockwise Clockwise to the pilot position.5. Slightly depress and turn control knob counterclockwise C-clockwise to the PILOTposition. Press in control knob for five (5) seconds (see Page 20).Note: You may be running this heater for the first time after hooking up to gassupply. If so, the control knob may need to be pressed in for 30 seconds. Thiswill allow air to bleed from the gas system.6. With control knob pressed in, press and release ignitor button. This will lightpilot. The pilot is attached to the burner. If needed, keep pressing ignitor buttonuntil pilot lights.Note: If pilot does not stay lit, contact a qualified service person or gas supplierfor repairs. Until repairs are made, light pilot with match. To light pilot withmatch, see Manual Lighting Procedure, page 22.7. Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds,release control knob.Note: If pilot goes out, repeat steps 3 through 7.ThermocoupleFigure 22 - PilotIgnitor ElectrodePilot Burner• If control knob does not pop out when released, contact a qualified serviceperson or gas supplier for repairs.8. Slightly depress and turn control knob counterclockwise C-clockwise to desiredheating level. The burner should light. Set control knob to any heat level betweenHI and LO.CAUTIONDo not try to adjust heating levels by using the manual shutoff valve.WARNINGDo not operate heater between PILOT and HIGH positions.VARIABLE CONTROL OPERATIONThe variable control valve can be set to any heat setting and flame height desired, bysimply turning the control knob until that setting is attained. Even the lowest settingprovides realistic, dancing yellow flames. Selecting higher settings produces greaterheat output. This results in increased heating comfort.Continued