Desa EFS33NRA Owner's Operation And Installation Manual

Also see for EFS33NR: OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

www.desatech.com107172-01K 9WARNING: This applianceis equipped for (natural or pro-pane/LP) gas. Field conversionis not permitted.ELECTRICAL HOOKUP(Models GA3700 Series and GA3700TSeries Blower Accessories and GA3555Internal Duplex Kit)This fireplace accepts a blower assembly with anelectrical cord. The electrical cord is five feet inlength. You must locate fireplace within reach ofa 120 volt grounded electrical outlet. If not, youmust install an electrical outlet within reach offireplace power cord. The GA3555 outlet acces-sory may be used for built-in applications withblower accessory installed.INSTALLING HOODInstall hood to rail already installed in fireplaceas shown in Figure 5. Use 3 Phillips screwsprovided.INSTALLATIONContinuedFigure 5 - Installing HoodScrewHoodRailFigure 7 - Attaching Brass Trim toFireplace (VSGF33NRA Shown)Figure 6 - Assembling Brass TrimSide BrassTrimTopBrassTrimSlotMitered EdgeSlotShimSet ScrewsAdjustingPlateTrimHangingScrewsAssembledBrass TrimHangingNotcheson TrimASSEMBLING AND ATTACHINGOPTIONAL BRASS TRIM(Included with Mantel Accessory)IMPORTANT: If you are recessing the firebox ina wall, do not attach brass trim at this time. SeeBuilt-In Fireplace Installation, page 11.Note: The instructions below show assemblingand attaching brass trim to fireplace.1.Remove packaging from three pieces of brass trim.2.Locate four brass screws, two adjusting plates withset screws and two shims in the hardware packet.3. Align shim under adjusting plate as shown inFigure 6.4. Slide one end of adjusting plate/shim in slot onmitered edge of top brass trim (see Figure 6).5. Slide other end of adjusting plate/shim in slot onmitered edge of side brass trim (see Figure 6).6. While firmly holding edges of brass trim to-gether, tighten both set screws on the adjustingplate with slotted screwdriver.7. Repeat steps 1 through 6 for other side.8. Tighten trim hanging screws (#10 x 6.25shoulder) into holes in cabinets. Place theassembled trim onto fireplace cabinet. Alignhanging notches on trim with hanging screwson side of fireplace (see Figure 7). Push trimfirmly into place, sliding hanging notches overhanging screws.