Desa EL36L Safety Information And Installation Manual

Contents

www.desatech.com 122663-01D10REPLACING SCREENS1. Open upper control panel door. Turnpower switch off.2. Open bi-fold doors (if equipped).3. Remove 2 screws securing screen rods(see Figure 14).4. Tilt rod down and remove from bracket.5. Remove old screen from rod and discard.Install new screen onto rod.6. Reinstall rod into bracket and replacescrews.7. Close doors.SERVICINgContinued2. Open bi-fold doors (if equipped) andscreens.3. Remove screws securing each side of logto brackets (see Figure 13, page 9).4. Carefully remove log.5. Remove screws from back corners andfront of top panel (see Figure 15). Removetop panel and set aside.Note: For LED drum and motor, onlyremove back screws. Top panel does nothave to be completely removed. Care-fully push top panel up to remove screenglass.6. Using gloves, gently remove glass panelby sliding it toward you. There is a rubberbumper on each corner of glass. Set asidein a safe location.7. Follow instructions on pages 11 thru 13 toreplace part.8. Using gloves, install glass by gently slid-ing, smooth side toward fireplace front,into brackets on either side that hold glassin place.9. Reinstall top panel. Pull top panel downso that screen glass seats into glassretainer.10. Reinstall screws from step 5.11. Reinstall log.12. Reinstall screws into brackets to securelog.13. Close screens and doors.14. Turn on power to unit (circuit breaker).Figure 14 - Removing Screen/Rod AssemblyScreenRodRetainingScrewMountingHolesREPLACING EMBER STRIP1. Follow steps 1 and 4 under Replacing Log,page 9.2. Locate ember LED strip (see Figure 13,page 9). Disconnect wire (right side).3. Remove ember LED strip by squeezingtop of standoffs and discard.4. Being careful not to break LED strip, pressnew ember LED strip onto standoffs.5. Reconnect wire to LED strip.6. Follow steps 5 through 7 under ReplacingLog, page 9.SERVICE PREPARATIONPerform steps 1 through 4 below, then locatepart that needs replacing in the instructionsthat follow.1. Open control panel door. Turn off powerto unit (circuit breaker).Figure 15 - Removing Screen Glass (allparts not shown for clarity)Screen GlassControlPanelDoorTop Panel