www.desatech.com113109-01G 19INSTALLATIONContinuedInstalling 9-Volt Battery in Hand-HeldRemote Control Unit1. Remove battery cover on back of remotecontrol unit.2. Attach terminal wires to the battery. Placebattery into the battery housing.3. Replace battery cover onto remote con-trol unit.Figure 31 - Installing Battery in Hand-Held Remote Control UnitBatteryCoverTerminalWiresRemoteControl Unit9-Volt BatteryBatteryHousingOPERATIOND. Do not use this appliance if any parthas been under water. Immediately calla qualified service technician to inspectthe appliance and to replace any part ofthe control system and any gas controlwhich has been under water.LIGHTINGINSTRUCTIONSWARNING: You must operatethis fireplace with the fireplacescreen in place. Make sure fire-place screen is installed beforerunning fireplace.NOTICE: During initial operationof new fireplace, burning logswill give off a paper-burningsmell. Open damper or windowto vent smell. This will only lasta few hours.1. STOP! Read the safety information,column 1.2. Make sure equipment shutoff valve isfully open.3. Set selector switch in OFF position.WARNING: Burner will comeon automatically within oneminute when the selector switchis in the ON position after thepilot is lit.FOR YOUR SAFETYREAD BEFORE LIGHTINGWARNING: If you do not fol-low these instructions exactly,a fire or explosion may resultcausing property damage, per-sonal injury or loss of life.A. This appliance has a pilot which mustbe lighted by hand. When lighting the pi-lot, follow these instructions exactly.B. BEFORE LIGHTING smell all aroundthe appliance area for gas. Be sure tosmell next to the floor because somegas is heavier than air and will settleon the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; donot use any phone in your building.• Immediately call your gas supplierfrom a neighbor’s phone. Follow thegas supplier’s instructions.• If you cannot reach your gas supplier,call the fire department.C. Use only your hand to push in or turnthe gas control knob. Never use tools.If the knob will not push in or turn byhand, don’t try to repair it, call a quali-fied service technician or gas supplier.Force or attempted repair may result ina fire or explosion.