Desa GXSVYD18NRA Owner's Operation And Installation Manual

Contents

www.desatech.com113084-01J 11INSTALLATIONContinuedcAUTION: Do not remove thedata plates attached to the heaterbase assembly. The data platescontain important warranty andsafety information.WARNING: Failure to posi-tion the parts in accordancewith these diagrams or failureto use only parts specificallyapproved with this heater mayresult in property damage orpersonal injury.INSTALLING GAS LOG INTO STOVE1. Remove log from carton.2. Remove all protective packaging appliedto log for shipment.3. Check log for any shipping damage. Ifdamaged (pieces larger than the size of adime), promptly inform dealer where youbought heater.4. Set one-piece log on heater base asshown in Figure 12. Make sure middlesection at bottom of log is seated into “U”shaped cutout in center of heater base.Log will fit securely on base. IMPORTANT:Make sure log does not cover any burnerports and does not touch the stove cavity(see Figure 13).5. Fasten back panel to stove with four M6x 1 bolts and washers.6. Place freestanding stove in desired posi-tion in room. Be sure to maintain clear-ances to combustibles as outlined onpage 8.cAUTION: After installa-tion and periodically thereafter,check to ensure that no flamecomes in contact with any log.With the heater set to HI, checkto see if flames contact any log. Ifso, reposition logs according tothe log installation instructionsin this manual. Flames contact-ing logs will create soot.Burner Porting Areas (doubleslotted rectangular openings)Figure 13 - Top View of One-Piece LogSet on Gas Log HeaterSafety Pilot LocationOne-PieceLog SetOne-PieceLog Set“U” ShapedCutout in ChassisBurnerMiddleSection atBottom ofLog SetFigure 12 - Installing One-Piece StoveLog SetHeater BasecONNEcTING TO GAS SUPPLYWARNING: This appliancerequires a 1/2" NPT (NationalPipe Thread) inlet connection tothe pressure regulator.WARNING: A qualified serviceperson must connect heater to gassupply. Follow all local codes.cAUTION: Never connectpropane/LP heater directly to thepropane/LP supply. This heaterrequires an external regulator(not supplied). Install the exter-nal regulator between the heaterand propane/LP supply.