108795-01F33For more information, visit www.desatech.comFor more information, visit www.desatech.comSAFETY INFORMATIONUNPACKING8. Turn fireplace off and let cool before servicing or repairing.Only a qualified service person should install, service, or re-pair this fireplace. Have fireplace inspected annually by a quali-fied service person.9. You must keep control compartments, burners, and circulatingair passages clean. More frequent cleaning may be needed dueto excessive lint and dust from carpeting, bedding material, etc.Turn off the gas valve and pilot light before cleaning fireplace.10. Have venting system inspected annually by a qualified serviceperson. If needed, have venting system cleaned or repaired.See Cleaning and Maintenance, page 20.11. Keep the area around your fireplace clear of combustible ma-terials, gasoline, and other flammable vapor and liquids. Donot run fireplace where these are used or stored. Do not placeitems such as clothing or decorations on or around fireplace.12. Do not use this fireplace to cook food or burn paper or otherobjects.13. Do not use any solid fuels (wood, coal, paper, cardboard, etc.)in this fireplace. Use only the gas type indicated on fireplacenameplate.14. This appliance, when installed, must be electrically groundedin accordance with local codes or, in the absence of local codes,with the National Electrical Code, ANSI/NFPA 70, or the Ca-nadian Electrical Code, CSA C22.1.15. Do not obstruct the flow of combustion and ventilation air inany way. Provide adequate clearances around air openings intothe combustion chamber along with adequate accessibilityclearance for servicing and proper operation.16. Do not install fireplace directly on carpeting, vinyl tile, or any com-bustible material other than wood. The fireplace must set on a metalor wood panel extending the full width and depth of the fireplace.17. Do not use fireplace if any part has been exposed to or underwater. Immediately call a qualified service person to arrangefor replacement of the unit.18. Do not operate fireplace if any log is broken.19. Do not use a blower insert, heat exchanger insert, or other ac-cessory not approved for use with this fireplace.20. Provide adequate clearances around air openings.SAFETY INFORMATIONContinuedUNPACKINGThe following items are packed inside the firebox. Remove beforepositioning firebox into framing.• Transition Collar - For vent connection• Ceramic Log Pack - Shrink-wrapped on cardboard• Three (3) plastic bags containing lava rock, pan and embermaterials• Rear Log - Remove the two plastic quick ties from around theburner and grate• Grate Stand - Lift off of burner panCheck all items for any shipping damage. If damaged, promptlyinform dealer or distributor where you bought the product.Safely retain these items for later installation.