Desa HDCFTN Owner's Operation And Installation Manual

Also see for CGCFTN: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

Desa HDCFTN Owner's Operation And Installation Manual Manual pdf 5 page image

www.desatech.com111044-01F 5PRODUCT FEATURESSAFETY PILOTThis fireplace has a pilot with an Oxygen Deple-tion Sensing (ODS) safety shutoff system. TheODS/pilot is a required feature for vent-free roomfireplaces. The ODS/pilot shuts off the fireplace ifthere is not enough fresh air.PIEZO IGNITION SYSTEMThis fireplace has a piezo ignitor. This systemrequires no matches, batteries or other sources tolight fireplace.THERMOSTATIC HEAT CONTROLThis fireplace has a thermostat sensing bulb and acontrol valve. The thermostat will automaticallymodulate the heat output to maintain a consistentroom temperature. This results in greater fireplacecomfort. This can also result in lower gas bills.UNPACKING1. Remove log box and fireplace from carton.IMPORTANT: The fireplace hood is insidethe cardboard protective end wrap on the leftside of fireplace (as viewed from front). Adecal is on the outside of the cardboard endwrap stating hood is enclosed (see Figure 2).2. Remove hood from cardboard protective endwrap as shown in Figure 2.3. Remove all protective packaging applied tofireplace for shipment.4. Make sure your fireplace includes one hard-ware packet.5. Check fireplace for any shipping damage. Iffireplace is damaged, promptly inform dealerwhere you bought fireplace.Figure 2 - Removing Fireplace HoodIMPORTANT:THIS PACKAGE CONTAINS AFIREPLACE HOOD. UNWRAPCARTON AND REMOVE HOODBEFORE DISCARDINGPROTECTIVE PACKAGING.12HoodCardboardProtectiveFireplaceEnd WrapHoodEnclosedDecalASSEMBLYWARNING: Always havebranch support and screen inplace before operating fireplace.This prevents excessive temper-atures on fireplace surfaces.WARNING: Failure to positionthe parts in accordance with thesediagrams or failure to use onlyparts specifically approved withthis fireplace may result in prop-erty damage or personal injury.ASSEMBLING FIREPLACETools Required:• Phillips screwdriver • slotted screwdriver• 5/16" hex wrench • scissorsInstalling Log1. Lift screen up and pull out to remove.2. Cut two plastic straps to remove the log fromthe firebox cavity.3.An optional blower is available for modelsCGCFTP and CGCFTN. See Accessories, page30. Install optional blower now. Follow instal-lation instructions provided with blower.4. Remove log packaging material and discardpackaging. Gently place log set on burnersupport (see Figure 3). The log should fit flatagainst top of burner support and log locatortabs fit into the slots under the log. Do notallow log to contact flame. If flame contactslog, soot will be created.5. Reattach screen by placing the notches in thescreen frame over the shoulder screws andpushing down.Figure 3 - Assembling FireplaceLogScreenBurner Supportwith LogLocator TabsBranchSupportShoulderScrew