Desa LMFP33NR(B) Owner's Operation And Installation Manual

Also see for LMFP33PR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Desa LMFP33NR(B) Owner's Operation And Installation Manual Manual pdf 22 page image

www.desatech.com 119526-01A22INSPECTING BURNERSCheck pilot flame pattern and burner flame pat-terns often.pILOT FLAME pATTERNFigure 35 shows a correct pilot flame pattern.Figure 36 shows an incorrect pilot flame pattern.The incorrect pilot flame is not properly heatingthe thermocouple. When the thermocouple cools,the heater will shut down.If pilot flame pattern is incorrect, as shown inFigure 36• turn heater off (see To Turn Off Gas to Appli-ance, page 20)• see Troubleshooting, page 24Note: The pilot flame on a natural gas units willhave a slight curve, but flame should be blue andhave no yellow or orange color.Figure 35 - Correct Pilot Flame PatternFigure 36 - Incorrect Pilot Flame PatternPilot Burner ThermocoupleThermocouplePilot BurnerThermocouplePilot BurnerThermocouplePilot BurnerNatural Gas PilotPropane/LP Gas PilotNatural Gas PilotPropane/LP Gas PilotBURNER pRIMARY AIR HOLESAir is drawn into the burner through the holes inthe fitting at the burner entrance. These holes maybecome blocked with dust or lint. Periodicallyinspect these holes for any blockage and clean ifneeded. Blocked air holes will create soot.MAIN BURNERPeriodically inspect all burner flame holes with thefireplace running. All slotted burner flame holesshould be open with yellow flame present. All roundburner flame holes should be open with a small blueflame present. Some burner flame holes may becomeblocked by debris or rust, with no flame present. Ifso, turn off fireplace and let cool. Remove blockage.Blocked burner flame holes will create soot.BURNER FLAME pATTERNWARNING: If yellow tippingoccurs, your fireplace couldproduce increased levels ofcarbon monoxide.NOTICE: Do not mistake orangeflames with yellow tipping. Dirtor other fine particles enter thefireplace and burn causing briefpatches of orange flame.Figure 37 shows a correct burner flame pattern. Fig-ure 38 shows an incorrect burner flame pattern. Theincorrect burner flame pattern shows the flame higherconsistently higher than 1 inch above the logs.If burner flame pattern is incorrect, as shown inFigure 38• turn heater off (see To Turn Off Gas To Appli-ance, page 20)• see Troubleshooting, page 24Figure 37 - Correct Burner Flame PatternYellow TippingFigure 38 - Incorrect Burner Flame Pattern