Desa M36E(B,H) Owner's Operation And Installation Manual

Also see for H): OWNER'S OPERATION AND INSTALLATION MANUAL Owner's operating and installation manual

Contents

Desa M36E(B,H) Owner's Operation And Installation Manual Manual pdf 19 page image

www.desatech.com108796-01T 19TO TURN OFF GASTO APPLIANCE1. Turn off wall switch.2. Turn off all electric power to appliance ifservice is to be performed.3. Fully open glass doors if installed.4. Remove front hearth brick and controlaccess panel.5. Turn gas control knob clockwiseto OFF. Do not force.6. Replace front refractory brick accesspanel.7. Fully close glass doors if installed.OPTIONAL REMOTEOPERATIONNote: The WRC receiver and hand-held re-mote control kit must be purchased separately(see Accessories, page 29). Follow installa-tion instructions on page 10.oPeratIoNContinuedFigure 38 - PilotSensingRodPilotBurnerIgnitorPilotBurnerIgnitor/SensorINsPeCtING burNersFigure 39 - Correct Pilot Flame PatternFigure 40 - Typical Flame PatternSensingRod1. Turn equipment shutoff valve to ON posi-tion. You can now turn burner on and offwith the hand-held remote control unit.IMPORTANT: Be sure to press ON/OFFbuttons on hand-held remote control unitfor up to 3 seconds to assure properoperation.2. Press the ON/OFF button to turn burneron and off.Check pilot flame pattern and burner flamepatterns often.PILOT ASSEMBLYThe pilot assembly is factory preset for theproper flame. Alterations may have occurredduring shipping and handling. The pilot islocated on the back right hand side of theburner.The flame must envelope 1/4" of top of theignitor/sensor and grounding stem.If your pilot assembly does not meet theserequirements:• Turn adjustment screw marked PILOTclockwise to decrease or counterclockwiseto increase the flame to proper size (seeFigure 37, page 19). Do not remove adjust-ment screw.• see Troubleshooting, page 22BURNER FLAME PATTERNBurner flames will be steady, not lifting orfloating. Flames should go up through themiddle of logset. Flames should not "spill" tothe edges of pan or sides of logset.Figure 40 shows a typical flame pattern. Ifburner flame pattern differs from that de-scribed:• turn appliance off (see To Turn Off Gas toAppliance)• see Troubleshooting, page 22