Desa NY100 Safety Information And Installation Manual

Contents

www.desatech.com118620-01E 115. Replace heater onto mounting bracket.6. Place spacers between bottom mountingholes and wall anchor or drilled hole.7. Hold spacer in place with one hand. Withother hand, insert mounting screw throughbottom mounting hole and spacer. Placetip of screw in opening of wall anchor ordrilled hole.8. Tighten both screws until heater is firmlysecured to wall. Do not over tighten.Note: Do not replace front panel at thistime. Replace front panel after makinggas connections and checking for leaks(see pages 12 through 14).MOUNTING HEATER TO FLOORWITH OPTIONAL FLOOR KITMounting Base Feet to HeaterNote: A 90° elbow is required for mountingthis unit and must be installed BEFORE basefeet to provide proper clearance (see Figure17, page 13).1. Lay heater cabinet on its back on a tablewith the heater bottom overhanging tableedge.2. Apply pipe joint sealant lightly to male NPTthreads of elbow. Hold pressure regulatorwith a wrench when connecting elbow.Do not overtighten elbow to regulator.Regulator body could be damaged.3. Align holes in base foot with mounting holeson bottom of cabinet (see Figure 12).4. Secure base foot to heater using sheetmetal screws.5. Repeat for other side.INSTALLATIONContinuedFigure 12 - Installing Base Feet (actualheater may vary from illustration)Sheet Metal ScrewWoodScrewBase FootMounting Base Feet to Floor1. Remove front panel (see Removing FrontPanel of Heater, page 9).2. Position heater with base feet in desiredlocation. Mark holes for drilling. Removeheater with base.3. For carpeted floors, make a small cut witha sharp knife at marked locations prior todrilling. If mounting base to a wood floor,drill 1/8" diameter hole, 3/4" deep. (Do notuse anchors in wood floors).If mounting base to a concrete floor, drillwith 1/4" diameter concrete drill bit, 13/8" intofloor. Insert anchors completely into holes.4. Reposition heater with base feet overholes. Secure base to floor with woodscrews. See Figure 12.INSTALLING REMOTE CONTROLRECEIvERRemote control receiver must be installed tooperate the remote control.Do not mix old and new batteries. Do not mixalkaline, standard (carbon - zinc) or recharge-able (nickel - cadmium) batteries.1. Locate two packages of AA batteries,remote receiver and hook and loop strip inhardware bag included with your heater.2. Remove battery cover on receiver andinstall batteries as shown in Figure 13.Replace battery cover.3. Remove adhesive backing on hook andloop strip and attach to receiver in locationshown in Figure 14, page 12.4. Place receiver with hook and loop strip’ssticky side down in approximate locationon inside of heater shown in Figure 14,page 12.5. Connect wires from receiver to wires oncontrol valve solenoid.REMOTEOFFBattery CoverReceiverFigure 13 - Installing Batteries inReceiverAA Batteries