Desa SVYD18N, SVYD18NR Owner's Operation And Installation Manual

Also see for SVYD18NR Series: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

Desa SVYD18N, SVYD18NR Owner's Operation And Installation Manual Manual pdf 8 page image

111162-01A8For more information, visit www.desatech.comFor more information, visit www.desatech.comINSTALLATIONContinuedFigure 6 - Laying Down Stove On Side (Stove Style May VaryDepending on Model)Front ofStoveUnit PalletWoodBolted toStoveBodyBottomTop of Stove UnitFront ofStove Unit Top ofStove UnitDropCloth/BlanketFigure 7 - Removing Pallet Wood From The Bottom of The StovePalletWoodBolt PalletWoodBottom OfStove UnitFrontSTOVE CAVITY ASSEMBLY1. Lift off corrugated box enclosing stove body crating.2. Remove all screws fastening the wood frame enclosure. Spreadwood frame open and lift away from plastic-bagged stove body.The bottom pieces of pallet wood will remain bolted to thestove body.3. Remove plastic bag from stove body.4. Remove back panel from stove (see Figure 5). Use an adjust-able wrench or a 10 mm socket. Remove six (6) bolts and wash-ers. Keep bolts and washers to reattach back panel later.5. Remove all contents from inside stove cavity. Contents include:(1) - Stove bottom(4) - Legs (Amity™ and Townsend™ models include leg lev-eler bolts)(1) - Bottom door(1) - Top grate(1) - Hardware kit bag with fasteners6. Carefully lay stove body on back to attach bottom componentsto stove body (see Figure 6). Rest stove on drop cloth or blan-ket to avoid scratching stove edges.7. Remove remaining pallet wood attached to bottom of stovebody (see Figure 7). Use an adjustable wrench to remove bolts.Figure 5 - Removing Back PanelBoltProductIdentificationLabelBack StovePanelFigure 8 - Locating Threaded Holes for Stove Bottom, Legs, andDoor Attachment (Appearance May Vary Depending on Model)Amity™ and Townsend™ Models8. Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts.Use a flat washer and lock washer with each bolt. Tighten boltsinto threaded holes on stove body (see Figures 8 and 9). Usean adjustable wrench or a 12mm socket.9. Fasten stove bottom to stove with four (4) M6 x 1 - 25mmbolts. Use a flat washer and lock washer with each bolt. Tightenbolts into threaded holes on stove body (see Figure 8 and Fig-ure 10, page 9). Use an adjustable wrench or a 10mm socket.LegHoleLegHoleLeg HoleLeg HoleDoor Hinge StepBolt HoleDoor Catch BoltWith AdjustableHex Nuts HoleHoles forStoveBottomFrontBottom OfStove UnitFigure 9 - Attaching Stove Legs (Amity™ Model Shown)Bottom OfStove UnitLegBoltWashersINSTALLATIONStove Cavity Assembly