Desa (V)K36N SERIES Owner's Operation And Installation Manual

111923-01BFor more information, visit www.desatech.comFor more information, visit www.desatech.com2323FIREPLACE INSTALLATIONContinuedFIREPLACE INSTALLATIONInstalling Logs, Lava Rock and Glowing EmbersOPERATING FIREPLACEFor Your Safety Read Before LightingFigure 47 - Installing Log No. 7INSTALLING LOGS, LAVA ROCK ANDGLOWING EMBERSEach log is marked with a number. These numbers will help youidentify the log when installing. It is very important to install theselogs exactly as instructed. Do not modify logs. Only use logssupplied with fireplace.Open louvers, remove screen, unlock door latches, and open glassdoor. See Removing/Replacing Glass Door, steps 1 and 2 on page 22.Install logs according to instructions for fireplace model numbers.1. Place log #1 (left base log) onto pin on left side of burner asshown in Figure 44.2. Place log #2 (right base log) onto pin on right side of burner asshown in Figure 44.3. Place logs #3 (left front log) and log #4 (right front log) ontopins as shown in Figure 45.4. Place log #5 (right rear log) onto pins on right rear of burner(see Figure 46). Rest log #6 (middle crossover log) on top oflog number 2 as shown in Figure 46.5. Place back end of log #7 (left rear log) onto pin on left rearburner and rest front onto log #1 as shown in Figure 47.6. Rest log #8 (left crossover log) onto log #3 and rest log #9 (rightcrossover log) onto logs #4 and #5 as shown in Figure 48.7. Pull ember material apart into pieces no larger than a dime. Placethese pieces loosely and sparingly directly onto the exposed frontsection of the burner (see Figure 49). This will create the glowingember appearance as the flame touches the ember material. Donot block air slots by using too much ember material in one area.It is not necessary to use all of the ember material provided.Figure 44 - Installing LogsNo. 1 and No. 2Figure 45 - Installing LogsNo. 3 and No. 4Figure 46 - Installing LogsNo. 5 and No. 612 3 456789Figure 48 - Installing Logs No. 8 and No. 9Ember MaterialFigure 49 - Placing Ember Material on BurnerWARNING: The glass door must be securely inplace before running this fireplace. Do not run thisfireplace if glass is missing or broken.NOTICE: Do not put lava rock on burner or underburner. Placing lava rock on burner will cause perfor-mance problems.8. Close glass door, lock door latches, replace screen, and closelouvers (see Removing/Replacing Glass Door, steps 5 through7 on page 22).OPERATING FIREPLACEWARNING: If you do not follow these instructionsexactly, a fire or explosion may result causing prop-erty damage, personal injury or loss of life.A. This appliance has a pilot which must be lighted by hand.When lighting the pilot, follow these instructions exactly.B. BEFORE LIGHTING smell all around the appliance areafor gas. Be sure to smell next to the floor because some gasis heavier than air and will settle on the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; do not use any phonein your building.• Immediately call your gas supplier from a neighbor'sphone. Follow the gas supplier's instructions.FOR YOUR SAFETY READBEFORE LIGHTING