Desa (V)T32N SERIES Owner's Operation And Installation Manual

Also see for CHDV32NR Series: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

www.desatech.com111986-01D 5INSTALLING OPTIONAL BRICKLINER MODEL BL32DWARNING: If fireplace hasbeen running, turn off and un-plug fireplace. Let cool beforeinstalling brick liner.This brick liner kit is optional. You may purchasebrick liner from your local retailer or see Acces-sories, page 36.CAUTION: Always handlebrick panels with two hands.Do not force brick panels intoplace. Excessive force will breakbrick panels.1. Remove top and bottom louvers to allow ac-cess to door latches.2. Remove screen, unlock door latches and openglass door. See Removing/Replacing GlassDoor, steps 1 and 2, page 24.3. If installing brick liner in new fireplace, go tostep 4. If installing brick liner in an existingfireplace, carefully remove logs, lava rock,and ember material.4. Remove three screws from deflector shield onthe inside top of firebox. Set shield and screwsaside.5. Install rear brick panel first. Rest bottom edge ofpanel on back edge of grate (see Figure 42).6. Install left side brick panel by sliding it betweengrate and side of firebox (see Figure 43).FIREPLACEINSTALLATIONContinuedFigure 42 - Installing Rear Brick PanelRear BrickPanelFigure 43 - Installing Side Brick PanelsLeft SideBrick Panel7. Install the right brick panel using the samemethod described8. Replace deflector shield using screws removedin step 4.9. Install logs, lava rock, and ember materialsee Installing Logs, Lava Rock and GlowingEmbers.10. Close glass door, lock latches on top and bottomof door and replace screen (see Removing/Re-placing Glass Door, steps 5 and 6, page 24).11. Close top and bottom louvers.INSTALLING LOGS, LAVA ROCKAND GLOWING EMBERSEach log is marked with a number. These numberswill help you identify the log when installing. Itis very important to install these logs exactly asinstructed. Do not modify logs. Only use logssupplied with fireplace.Open louvers, remove screen, unlock door latches,and open glass door. See Removing/ReplacingGlass Door, steps 1 and 2, page 24. Install logsaccording to instructions for fireplace modelnumbers.1. Place log #1 (rear log) on top of grate. Makesure notches in bottom of log fit over grate(see Figure 44, page 26).2. Rest log #2 (front log) on pins on front part ofgrate (see Figure 45, page 26).3. Place log #3 (crossover log) onto rear and frontlogs. Make sure it is seated properly on smoothsurface of front log and pin on back log as shownin Figure 46, page 26.4. Place log #4 (right log) onto pin on right sideof front log as shown in Figure 47, page 26.5. Place log #5 (base log) onto front left part ofgrate making sure notches fit over prongs ofgrate. See Figure 48, page 26.