Desa (V)V36N Owner's Operation And Installation Manual

108861For more information, visit www.desatech.comFor more information, visit www.desatech.com2525FIREPLACE INSTALLATIONInstalling Logs, Lava Rock and Glowing Embers (Cont.)FIREPLACE INSTALLATIONContinuedWARNING: The glass door must be securely inplace before running this fireplace. Do not run thisfireplace if glass is missing or broken.NOTICE: Do not put lava rock on burner or underburner. Placing lava rock on burner will cause perfor-mance problems.9. Pull ember material apart into pieces no larger than a dime.Place these pieces loosely and sparingly directly onto the ex-posed section of the front burner and along the space betweenthe burner and grate prongs (see Figure 51). This will createthe glowing ember appearance as the flame touches the embermaterial. Do not block air slots by using too much ember ma-terial in one area. It is not necessary to use all of the embermaterial provided.10. Close glass door, lock door latches, replace screen, and closelouvers (see Removing/Replacing Glass Door, steps 5 through7 on page 23).56 74Ember MaterialFigure 51 - Placing Ember Material on BurnerFigure 49 - Installing Log No. 5Figure 50 - Installing Log No. 6 (36" and 42" Series) andLog No. 7 (42" Series Only)42" Series OnlyFigure 48 - Installing Log No. 44. Place log #4 (crossover log) onto pins from both logs #2 and#3 as shown in Figure 48.5. Place log #5 (top log) onto right pin of front log (#2) and thesmooth surface of crossover log (#4) as shown in Figure 49.Make sure it is seated properly.6. Place log #6 (left log) onto left pin of front log (#2) and thesmooth surface of rear log (#3) as shown in Figure 50. Makesure it is seated properly.7. For (V)V42 series only, place log #7 onto right pin of top log(#5) as shown in Figure 50. Make sure it is seated properly8. Place lava rock along sides and front of firebox bottom in ar-eas that are visible only. It is not necessary to use all of thelava rock provided.