Desa (V)V42NA(1) Owner's Operation And Installation Manual

Also see for (V)V42NA(1): OWNER'S OPERATION AND INSTALLATION MANUAL

111906-01AFor more information, visit www.desatech.comFor more information, visit www.desatech.com2323LockUnlockFIREPLACE INSTALLATIONContinuedFIREPLACE INSTALLATIONRemoving/Replacing Glass DoorInstalling Optional Brick Liner Models BL42DA(SA) and BL42DHA(SA)REMOVING/REPLACING GLASS DOORCAUTION: Do not operate this fireplace with abroken glass door panel or without the glass doorpanel securely in place. For replacement part infor-mation seeReplacement Parts, page 33.Removing Louver PanelsRemove the top and bottom louver panels by simultaneously pullingboth top end spring latches towards the center of the appliance untilthey are disengaged from the locating holes (see Figure 41). Repeatfor bottom spring latches and pull the louvers outward. To install orreplace items removed, simply reverse the procedures above.Figure 41 - Removing Louver PanelLouver PanelGlass FrameAssemblyScrewFigure 42 - Removing/Replacing Glass DoorINSTALLING OPTIONAL BRICK LINER MODELSBL42DA(SA) AND BL42DHA(SA)WARNING: If fireplace has been running, turnoff and unplug fireplace. Let cool before installingbrick liner.This brick liner kit is optional. You may purchase brick liner fromyour local retailer or see Accessories, page 38.CAUTION: Always handle brick panels with twohands. Do not force brick panels into place. Exces-sive force will break brick panels.1. Remove top and bottom louvers to allow access to door latches.2. Unlock door latches and open glass door. See Removing/Re-placing Glass Door, steps 1 and 2.3. If installing brick liner in new fireplace, go to step 4. If install-ing brick liner in an existing fireplace, carefully remove logs,lava rock, and ember material.4. Remove three screws from deflector shield on the inside topof firebox. Set shield and screws aside.CAUTION: Wear gloves and safety glasses whilehandling or removing broken glass. Do not remove ifglass is hot. Keep children and pets away from glass.WARNING: If fireplace has been running, turnoff and unplug fireplace. Let cool before removingglass door or louvers.Spring LatchHingeRemoving Glass DoorsIf replacement of glass is necessary, the entire assembly, glass andframe, must be replaced. If glass is broken, wear gloves and tape theremaining fragments onto the frame.1. Remove screen assembly by pushing the rod either left or rightand then down and forward to remove screen/rod assemblyfrom the firebox. Set assembly aside.2. Lift up on latches to unlock. There are two on top of firebox andtwo below firebox that hold glass door in place (see Figure 42).3. While holding glass door to prevent it from falling and caus-ing injury, remove the five screws from the hinge located onthe left side of door frame assembly (see Figure 42).4. Remount the new frame at the hinge with five new screwsbefore closing door. This will ensure seating of the gasket.5. Close glass door frame. Lock latches by placing the bar under thetab on door and pushing down and back on latch (see Figure 42).Latch6. Replace screen/rod assembly by reversing step 1.7. Replace louvers by reversing procedure under RemovingLouver Panels.Cleaning Glass DoorSee Cleaning and Maintenance on page 29.