Desa VKC42PE SERIES Owner's Operation And Installation Manual

Also see for (V)KC42NE SERIE: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

www.desatech.com 116240-01E267. Remove three screws from deflector shield onthe inside top of firebox. Set shield and screwsaside.8. Install rear brick panel first. Rest bottom edgeof panel on back edge of burner assembly (seeFigure 39).9. Install left side brick panel by sliding it be-tween the burner assembly and the side of thefirebox (see Figure 39).10. Install the right brick panel using the samemethod described in step 6 for left brickpanel.11. Replace deflector shield using screws removedin step 7.12. Using screws removed in step 6, replaceplenum and attach to burner.13. Carefully replace the ember pod and log set.14. Use screws removed in step 4 to replaceandiron assembly.15. Install lava rock and glowing embers. SeeInstalling Lava Rock and Glowing Embers,page 25.16. Close glass door and lock latches on top andbottom of door and replace screen. See Re-moving Glass Door, steps 5 and 6, page 25.17. Replace top and bottom louvers.FIREPLACEINSTALLATIONContinuedFigure 39 - Installing Rear Brick PanelRear Brick PanelLeft Side BrickPanelWALL SWITCH INSTALLATIONThe installation of a wall switch allows you to ac-tivate the gas control valve and turn the fireplaceon and off. The wall switch is to be connected tothe incoming 120 volt regular household wiringthat supplies the electricity to the fireplace.OpTIONAL REMOTE CONTROLINSTALLATION (MODEL WRC)Note: If using optional wireless hand-held remotecontrol, the wall switch must be in the ON positionto be operational. The remote control then becomesthe switching mechanism for fireplace operation.1. Open lower louver panel.2. The WRC model receiver does not require abattery. The receiver can be installed by firstplugging the short extension cord into thefireplace receptacle. Then plug the receiverunit into the extension cord. Finally plug theignition module plug into the receiver unit (seeFigure 40).3. Activate the remote handset battery byremoving the insulating tab on the back ofthe handset (see Figure 41). The battery isincluded pre-installed.4. Once the battery is activated the unit is readyto use.5. Close lower louver panel.Figure 40 - Installing the WRC RemoteReceiverFireplaceReceptacleRemoteControlReceiverExtension Cord IgnitionModule PlugFigure 41 - Installing Battery into Back ofHandsetPull to RemoveInsulation TabBattery Cover12 Volt BatteryBack ofHandset