Desa VRL24NR Owner's Operation And Installation Manual

Also see for CSG3924NR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL Owner's operating & installation manual

Desa VRL24NR Owner's Operation And Installation Manual Manual pdf 25 page image

www.desatech.com110021-01N 25LocksSystem toPreventAccidentalIgnitionManual Mode1. Press the POWER and LOCK buttonstogether to turn on the hand-held remotecontrol.2. Press the MANU button to turn on thefireplace.3. Press the POWER and LOCK buttonstogether to turn off the fireplace.Auto (Thermostatic) Mode1. Press the POWER and LOCK buttonstogether to turn on the hand-held remotecontrol.2. Press AUTO button to select this mode.3. Set the desired room temperature by press-ing the TEMP + or - buttons.4. Press the POWER and LOCK buttonstogether to turn off the fireplace.Note: Do not leave the hand-held remote in theAUTO mode close to the fireplace. The radiantheat from the fireplace will turn off the fireplace.Ideally, place the hand-held remote in the centerof the room facing towards the fireplace.Note: Do not hold the hand-held remote fora long time. Body temperature will affect itsoperation in the AUTO mode.Safety FeaturesWhen away from home for an extended periodof time or as a child safety feature to preventaccidental ignition of the fireplace, the receiverON/OFF/REMOTE switch should be in theOFF position.Figure 35 - Thermostat Hand-HeldRemote Control Unit (HRC200)OPERATING HEATERContinuedAuto Shutoff Feature1. If the average room temperature exceeds 82degrees Fahrenheit (28 degrees Centigrade),the hand-held remote control will perform asafety override and shut the fireplace off. Thisfeature is not available in the MANU mode.2. The receiver continuously receives signalsfrom the hand-held remote to control theroom temperature. If the hand-held remoteis misplaced, obstructed or for any reasoncannot transmit to the receiver, the receiverwill shut off the fireplace after 8 minutes.Key Pad Lock FeatureThis feature allows the user to lock/unlockthe keypad on the hand-held remote in theMANU or AUTO mode to prevent inadvertentoperation (i.e. children operating the hand-heldremote control, etc.). The keypad is locked ineither on or off. Press the POWER and LOCKbuttons together to turn the unit on or off.INSPECTING BURNERSCheck pilot flame pattern and burner flame pat-terns often.PILOT FLAME PATTERNFigure 36 shows a correct pilot flame pattern.Figure 37 shows an incorrect pilot flame pat-tern. The incorrect pilot flame is not touching thethermocouple. This will cause the thermocouple tocool. When the thermocouple cools, the heater willshut down.If pilot flame pattern is incorrect, as shown inFigure 37• turn heater off (see To Turn Off Gas to Ap-pliance, page 21 [thermostatically-controlledmodel] or page 24 [remote-ready models])• see Troubleshooting, page 28Note: The pilot flame on natural gas units willhave a slight curve, but flame should be blue andhave no yellow or orange color.PilotBurner ThermocoupleFigure 36 - CorrectPilot Flame Pattern(Natural Gas PilotShown)Figure 37 - IncorrectPilot Flame Pattern(Natural Gas PilotShown)PilotBurnerThermocoupleLOCKMANU AUTOºC/ºFTEMP POWERROOMTEMPSETTEMPAUTOTurns Hand-Held RemoteOn or Off andAllows Youto Choosethe ManualSettingSelects AUTOMode°C/°F ModeButtonTurnsBurnersOn or OffIncreases orDecreases RoomTemperature inAUTO ModeDigitalDisplayShowsTemperatureand SettingsIndicatorLight