Desa VT32EN Series Owner's Operation And Installation Manual

Also see for T32EN Series: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

www.desatech.com 108860-01D0FIREPLACE INSTALLATIONContinuedFigure 38 - Installing Rear Brick PanelFigure 39 - Installing Left Side and Top Brick PanelsRear Brick PanelLeft SideBrick PanelTop Brick Panel(T36 Series Only)INStALLING LOGS, LAvA ROCK ANDGLOWING EMbERSNote: 36" models shown. Logs will vary slightly for 32" models.Each log is marked with a number. These numbers will help youidentify the log when installing. It is very important to install theselogs exactly as instructed. Do not modify logs. Only use logs sup-plied with fireplace.Open louvers, remove screen, unlock door latches, and open glassdoor. See steps 1 and 2 of Removing/Replacing Glass Door, page 19.Install logs according to instructions for fireplace model numbers.1. Place log #1 (rear log) on top of grate. Make sure the notchesin the bottom of the log fit over the grate (see Figure 40).2. Rest log #2 (large front log) on the pins on the front part of thegrate (see Figure 41).12Figure 40 - Installing Log No. 1Figure 41 - Installing Log No. 25. Install rear brick panel first. Rest bottom edge of panel on backedge of grate (see Figure 38).6. Install top brick panel (36" Series only) by resting on the topof the rear panel. Hold the top brick panel in place and installleft side brick panel by sliding it between the grate and the sideof the firebox, securing top panel (see Figure 39).7. Install the right brick panel using the same method describedin step 6 for the left brick panel.8. Replace deflector shield using screws removed in step 4.9. Follow instructions starting in column 2 to install logs, lavarock, and ember material.10. Close glass door, lock latches on top and bottom of door andreplace screen (see steps 5 and 6 of Removing/Replacing GlassDoor, page 19).11. Close top and bottom louvers.