Desa VT32EN Series Owner's Operation And Installation Manual

Also see for T32EN Series: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

www.desatech.com108860-01D 1FIREPLACE INSTALLATIONContinued3. Place log #3 (crossover log) onto the rear and front logs. Makesure it is seated properly on the smooth surface on the front logand on the pin on the back log as shown in Figure 42.4. Place log #4 (right log) on the pin on the right side of front logas shown in Figure 43.5. Place log #5 (base log) onto the front left part of the gratemaking sure the notches fit over the prongs of the grate). SeeFigure 44.6. Place log #6 (left log) onto two pins on the left side of backand front log. See Figure 44.7. Place lava rock along sides and front of firebox bottom in areasthat are visible only. It is not necessary to use all of the lavarock provided.NOtICE: Do not put lava rock on burner or under burner.Placing lava rock on burner will cause performanceproblems.8. Pull ember material apart into pieces no larger than a dime.Place these pieces loosely and sparingly directly onto the ex-posed section of the front burner and along the space betweenthe burner and grate prongs (see Figure 45). This will createthe glowing ember appearance as the flame touches the embermaterial. Do not block air slots by using too much embermaterial in one area. It is not necessary to use all of the embermaterial provided.9. Close glass door, lock door latches, replace screen and closelouvers (see steps 5 and 7 of Removing/Replacing Glass Door,page 19).WARNING: The glass door must be securely in placebefore running this fireplace. Do not run this fireplaceif glass is missing or broken.4Ember MaterialFigure 45 - Placing Ember Material on BurnerFigure 43 - Installing Log No. 456Figure 44 - Installing Logs No. 5 and No. 63Figure 42 - Installing Log No. 3