Desa VT32EP Series Owner's Operation And Installation Manual

Also see for T32EN Series: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

108860For more information, visit www.desatech.comFor more information, visit www.desatech.com6FixedClosed Openable FixedClosedOpenableVVVVV VVVXXV XGGJFBBKNHIANELDBMACBVV AGGBTERMINATION CAP AIR SUPPLY INLET GAS METER RESTRICTED AREA(TERMINATION PROHIBITED)A = clearance above grade, veranda, porch, deck, or balcony[*12 inches (305mm) minimum]B = clearance to window or door that may be opened[12 inches (305mm) minimum]C = clearance to permanently closed window [minimum 12 inches(305mm) recommended to prevent condensation on window]D = vertical clearance to ventilated soffit located above the terminalwithin a horizontal distance of 24 inches (610mm) from thecenter-line of the terminal [18 inches (457mm) minimum]E = clearance to unventilated soffit [12 inches (305mm) minimum]F = clearance to outside corner (see below)G = clearance to inside corner (see below)H = *not to be installed above a meter/regulator assembly within36 inches (914mm) horizontally from the center-line of the regulatorI = clearance to service regulator vent outlet [*72 inches (1829mm)minimum]J = clearance to non-mechanical air supply inlet to building or thecombustion air inlet to any other fireplace [*12 inches (305mm)minimum]K = clearance to a mechanical air supply inlet [*72 inches (1829mm)minimum]L = clearance above paved side-walk or a paved driveway located onpublic property [*84 inches (2133mm) minimum]M = clearance under veranda, porch, deck [*12 inches (305mm) minimum ]N = clearance above a roof shall extend a minimum of 24 inches (610mm)above the highest point when it passes through the roof surface andany other obstruction within a horizontal distance of 18 inches (457mm)vent shall not terminate directly above a side-walk or paved driveway which is located between twosingle family dwellings and serves both dwellings*only permitted if veranda, porch, deck or balconey is fully open on a minimum of 2 sides beneath the floor** as specified in CAN/SGA B149 (.1 or .2) Installation Codes (1991) for Canada or for U.S.A. installation followthe currentNational Fuel Gas Code, ANS Z223.1Note: Local codes or regulations may require different clearancesA = 6" (152mm)Inside CornerVBEVB = 6" (152mm)C = Maximum depth of 48" (1219mm) forrecessed locationD = Minimum width for back wall ofrecessed location -Combustible - 38" (965mm)Noncombustible - 24" (610mm)E = Clearance from corner inrecessed location-Combustible - 6" (152mm)Noncombustible - 2" (51mm)Outside Corner Recessed LocationGHG = 12" (305mm) minimum clearanceBalcony with No Side WallVJCombustible &NoncombustibleH = 24" (610mm)J = 20" (508mm)Balcony with Perpendicular Side WallCDCTermination Clearances for Buildings with Combustible and Noncombustible ExteriorsFigure 7 - Minimum Clearances for Termination CapLOCATION OF TERMINATION CAPLOCATION OF TERMINATION CAP