Desa VV36ENA1 Series Owner's Operation And Installation Manual

Also see for VICTORIAN V36EN-A Series: OWNER'S OPERATION AND INSTALLATION MANUAL

111253-01AFor more information, visit www.desatech.comFor more information, visit www.desatech.com2323FIREPLACE INSTALLATIONContinuedFIREPLACE INSTALLATIONInstalling Logs, Lava Rock, and Glowing EmbersFigure 41- Installing Log No. 22Figure 42 - Installing Log No. 332. Rest left side of log #2 (front log) onto top of log #1. Placeright side of log onto second pin located on right side of grate(see Figure 41).3. Place log #3 (rear log) onto pins on rear of grate as shown inFigure 42.4. Place log #4 (crossover log) onto pins from both logs #2 and#3 as shown in Figure 43.5. Place log #5 (top log) onto right pin of front log (#2) and thesmooth surface of crossover log (#4) as shown in Figure 44.Make sure it is seated properly.6. Place log #6 (left log) onto left pin of front log (#2) and thesmooth surface of rear log (#3) as shown in Figure 45. Makesure it is seated properly.8. Place lava rock along sides and front of firebox bottom in ar-eas that are visible only. It is not necessary to use all of thelava rock provided.NOTICE: Do not put lava rock on burner or underburner. Placing lava rock on burner will cause perfor-mance problems.9. Pull ember material apart into pieces no larger than a dime.Place these pieces loosely and sparingly directly onto the ex-posed section of the front burner and along the space betweenthe burner and grate prongs (see Figure 46). This will createthe glowing ember appearance as the flame touches the embermaterial. Do not block air slots by using too much ember ma-terial in one area. It is not necessary to use all of the embermaterial provided.10. Close glass door, lock door latches, replace screen, and closelouvers (see Removing/Replacing Glass Door, steps 5 through7, page 21).WARNING: The glass door must be securely inplace before running this fireplace. Do not run thisfireplace if glass is missing or broken.Ember MaterialFigure 46 - Placing Ember Material on BurnerFigure 44 - Installing Log No. 556Figure 45 - Installing Log No. 6Figure 43 - Installing Log No. 44