Desa Vanguard GVC35PA Owner's Operation And Installation Manual

Desa Vanguard GVC35PA Owner's Operation And Installation Manual Manual pdf 6 page image

6100748Install and use heater with care. Follow all local codes. In the absence of localcodes, use the latest edition of the following:• National Fuel Gas Code ANSI Z223.1, also known as NFPA 54 *• National Electrical Code ANSI/NFPA 70 *• National Standard of Canada CAN1-B149 ***Available from: American National Standards Institute, Inc., 1430 Broadway,New York, NY 10018; or National Fire Protection Association, Inc., BatterymarchPark, Quincy, MA 02269**Available from: Standards Council of Canada, 350 Sparks Street, Ottawa,Ontario, K1R 7S8LOCAL CODESUNPACKING 1. Remove heater from carton.2. Remove all protective packaging applied to heater for shipment.3. Check heater for any shipping damage. If heater is damaged, promptly informdealer where you bought heater.PRODUCTFEATURESPiezo Ignition SystemThis heater has a piezo ignitor. This system requires no matches, batteries, or othersources to light heater.Thermostatic Heat ControlThis heater has a thermostat sensing bulb and a control valve. This results in thegreatest heating comfort. This can also result in lower gas bills.NOTICEThis heater must be electrically grounded if equipped withblower. Follow all local codes. In the absence of localcodes, follow the National Electric Code, ANSI/NFPA 70(U.S.) or Canadian Electrical Code CSA C22.1 (Canada).INSTALLINGHEATER WARNINGA qualified service person must install heater and ventingsystem. Have them inspect heater before use and at leastannually. Follow all local codes.CHECK GAS TYPEUse only propane gas. If your gas supply is not propane, do not install heater. Calldealer where you bought heater for proper type heater.INSTALLATION ITEMSBefore installing heater, make sure you have all items below.• external regulator (supplied byinstaller, see page 11)• piping (check local codes)• sealant (resistant to propane gas)• manual shutoff valve *• ground joint union• test gauge connection * (seeFigure 7, page 12)• sediment trap• tee joint• pipe wrench• venting materials* An A.G.A. design-certified manual shutoff valve with 1/8" NPT tap is anacceptable alternative to test gauge connection. Purchase the optional A.G.A.design-certified manual shutoff valve from your dealer. See Accessories, page 31.