Eaton 93E UPS 15-80 kVA (380/400/415 V) Installation and Operation Manual© Eaton Corporation plc 2015. All rights reserved. Revision: 001 Document ID: 614-01975-00 25 (133)4.1 Creating an installation planBefore you install the UPS system, read and understand how theseinstructions apply to the system that you are going to install. Use theprocedures and illustrations in Section 4.3 and Chapter 5 to create alogical plan for installing the system.4.2 Installation checklistAction Yes/NoAll packing materials and restraints are removed from each cabinet.The UPS cabinet is placed in its installed location.All conduits and cables are properly routed to the UPS and anyancillary cabinets.A readily accessible disconnect device is installed between the UPSinput and utility power.All power cables are properly sized and terminated.Neutral conductors are installed.A ground conductor is properly installed.(OPTIONAL) Signal inputs are wired appropriately.(OPTIONAL) LAN drops are installed.(OPTIONAL) LAN connections have been completed.(OPTIONAL) The remote EPO device is mounted in its installedlocation and its cabling is terminated inside the UPS cabinet.(OPTIONAL) If a normally-closed remote EPO switch is used, a jumperwire is connected between pins 3 and 4 on the remote EPO terminalblock.All terminal cover plates are installed.(OPTIONAL) Accessories are mounted in their installed locations andtheir cabling is terminated inside the UPS cabinet.Air conditioning equipment is installed and operating correctly.
