Eaton 93PM Installation And Operation Manual

Also see for 93PM IBC-L: User and installation guide Manual Installation and operation manual User and installation guide User and installation guide

Contents

Eaton 93PM Integrated Accessory Cabinet-Distribution (50–200 kW) Installation and Operation Manual P-164000229—Rev 6 www.eaton.com/powerquality 4-1Chapter 4 Installation4.1 Preliminary Installation InformationWARNINGInstallation should be performed only by qualified personnel.When installing the Eaton 93PM Integrated Accessory Cabinet-Distribution (IAC-D):l See Chapter 3 for cabinet dimensions, equipment weight, wiring and terminal data, and installation notes.l Do not tilt the IAC-D more than 10 vertical or the cabinet may tip over.4.2 Unloading the IAC-D Cabinet from the PalletDANGERRISK OF INSTABILITY. Do not remove any internal panels until the cabinet is removed from andlowered from the pallet.WARNINGThe IAC-D is heavy (see Table 3-2). If unpacking and unloading instructions are not closelyfollowed, the cabinet may tip and cause serious injury.CAUTIONl Do not tilt the IAC-D more than 10° from vertical or the cabinet may tip over.l Lift the cabinets only with a forklift or pallet jack or damage may occur.The IAC-D is bolted to a pallet consisting of two metal angle supports and two flat supports secured to twowood supports.1. If not already accomplished, use a forklift or pallet jack to move the IAC-D to the installation area, or asclose as possible, before unloading from the pallet. Insert the forklift or pallet jack forks between thesupports on the bottom of the pallet (see Figure 3-3 for the IAC-D cabinet center of gravitymeasurements).2. Open the front door (see Figure 4-1) by lifting the latch from the bottom and turning to the right(counterclockwise) and swing the door open.3. Locate the four 1/2" jacking bolts from the parts bag packed inside the front door and install them in thethreaded holes in the front and rear supports as shown in Figure 4-1. Place a floor protector from the partskit underneath each jacking bolt, and screw the bolts down against them.The floor protectors protect the floor from being marred by the jacking bolts.4. Loosen, but do not remove, the skid mounting bolts holding the left, right, front, rear, and two centersupports to the pallet skids (see Figure 4-1). DO NOT loosen or remove the cabinet mounting bolts or thecabinet support bolts.NOTE Before performing the IAC-D unloading, verify that the forklift or pallet jack is ratedto handle the weight of the cabinet (see Table 3-2 for cabinet weight).