Eaton 9E Installation And Operation Manual

Also see for 9E: Installation and operation manual Installation and operation manual Installation and operation manual Manual Manual

UPS System InstallationEaton 9E UPS (40–60 kVA, 208/220V) Installation and Operation Manual P-164000058—Rev 4 www.eaton.com/powerquality 4-7Figure 4-6. UPS Power Terminal Cover Base Installation and Conduit Landing Wire Entry Locations4.4 External Battery Cabinet InstallationIf installing External Battery Cabinets (EBCs), refer to the Eaton 9E External Battery Cabinet Installation Manuallisted in paragraph 1.8 for installation instructions.After the EBC is installed, proceed to paragraph 4.5 if installing an Integrated Transformer Cabinet (ITC), toparagraph 4.6 if installing an Integrated Accessory Cabinet-Bypass (IAC-B), to paragraph 4.7 if installing aIntegrated Accessory Cabinet-Tie (IAC-T), to paragraph 4.8 if installing a Integrated Accessory Cabinet-Tie andBypass (IAC-TB), or to paragraph 4.9 if installing an Integrated Accessory Cabinet-Distribution (IAC-D);otherwise, proceed to paragraph 4.10 to complete the wiring of the UPS.4.5 Integrated Transformer Cabinet InstallationIf installing an Integrated Transformer Cabinet (ITC), refer to the Eaton 9E Integrated Transformer CabinetInstallation Manual listed in paragraph 1.8 for installation instructions.After the ITC is installed, proceed to paragraph 4.6 if installing an IAC-B, or to paragraph 4.9 if installing an IAC-D;otherwise, proceed to paragraph 4.10 to complete the wiring of the UPS.Conduit Landing for AC Input, Output,and Bypass, DC Input, and REPO.(Install conduit to bottom of plate.)Power Terminal CoverBase InstalledBack