Eaton 9SX Series Installation And User Manual

Also see for 9SX Series: Manual Manual

Page 39614-20306-00 - 9SX 0-6 KVA EMEA_EN5. Operation5.1 Start-up and Normal operationTo start the UPS:1. Verify that the UPS power cord is plugged in.2. The UPS front panel display illuminates and shows EATON logo.3. Verify that the UPS status screen shows .4. Press the button on the UPS front panel for at least 2 seconds.The UPS front panel display changes status to "UPS starting...".5. Check the UPS front panel display for active alarms or notices. Resolve any active alarms before continuing.See "Troubleshooting" on page 50.If the indicator is on, do not proceed until all alarms are clear. Check the UPS status from the front panelto view the active alarms. Correct the alarms and restart if necessary.6. Verify that the indicator illuminates solid, indicating that the UPS is operating normally and any loadsare powered and protected.The UPS should be in Normal mode.5.2 Starting the UPS on BatteryBefore using this feature, the UPS must have been powered by utility power with output enabled at leastonce. Battery start can be disabled. See the "Cold start" setting in "ON/OFF Settings" on page 32.To start the UPS on battery:1. Press the button on the UPS front panel until the UPS front panel display illuminates and showsa status of "UPS starting...".The UPS transfers from Standby mode to Battery mode. The indicator illuminates solid.The UPS supplies power to your equipment.2. Check the UPS front panel display for active alarms or notices besides the "Battery mode" noticeand notices that indicate missing utility power. Resolve any active alarms before continuing.See "Troubleshooting" on page 50.Check the UPS status from the front panel to view the active alarms. Correct the alarms and restartif necessary.5.3 UPS ShutdownTo shut down the UPS:1. Press the button on the front panel for 3 seconds.A confirmation message will appear.When confirmed, the UPS starts to beep and shows a status of "UPS shutting OFF...". The UPS thentransfers to Standby mode, and the indicator turns off.5.4 Operating modesThe Eaton 9SX front panel indicates the UPS status through the UPS indicators, see page 29.Online modeDuring Online mode, the indicator illuminates solid and the UPS is powered from the utility.The UPS monitors and charges the batteries as needed and provides filtered power protection to yourequipment. Optional High Efficiency and Energy Saving settings minimize heat contribution to the rackenvironment. See user settings on page 31.Battery modeWhen the UPS is operating during a power outage, the alarm beeps once every 10 seconds and theindicator illuminates solid. The necessary energy is provided by the battery.When the utility power returns, the UPS transfers to Online mode operation while the battery recharges.If battery capacity becomes low while on Battery mode, the audible alarm beeps once every 3 seconds.This warning is approximate, and the actual time to shutdown may vary significantly.Shutdown all applications on the connected equipment because automatic UPS shutdown is imminent.When utility power is restored after the UPS shuts down, the UPS automatically restarts.