Eaton 9SX Series Manual

Also see for 9SX 15KPMAU Series: Manual User manual

1125. After the UPS is powered off again, insert the EPO terminal and power iton again• Press the button for more than 1 second, the buzzer will beep and theUPS will start up. After a few seconds, the UPS enters the mainsmode.• If the utility power is abnormal, the UPS will transfer to Battery mod.• When the battery is not connected, the UPS can still be startup. Afterthe startup, there is alarm of battery not connected. If the utilitypower is abnormal, the UPS load will not be protected.• The load is powered by the UPS and the LCD shows a charging signindicating that the battery is charging.• Startup the output device.Startup the UPS on Battery(Without utility power)When the UPS is connected to the battery, wait at least 10 secondsbefore pressing the power button.The battery can be turned on or disabled. For details, see 7.3.4 Settings →Battery Setting.Make sure all connections are correct.• Press the button for more than 0.1 seconds. The UPS establishes thepower, the fan starts to rotate, the LCD displays the startup animation,and then enters the main page to display the standby mode.• If there is no operation, the LCD is off out after 10 seconds and the UPS ispowered down.• Press the button for more than 1 second, the buzzer will beep and theUPS will startup. The UPS enters battery mode after a few seconds.• If the utility power is connected at this time, the UPS will switch to the linemode and the output will be uninterrupted.